specifications - FAACO - Federal Aviation Administration Contract ...

FTWIC-2235June, 2009.I. Shop drawings: As used in this section, drawings, schedules, diagrams, and other dataprepared specifically for this Contract, by the Contractor or through the Contractor byway of a subcontractor, manufacturer, supplier, distributor, or other lower tier contractor,to illustrate a portion of the work.J. Product data: Preprinted material such as illustrations, standard schedules, performancecharts, instructions, brochures, diagrams, manufacturer's descriptive literature, catalogdata, and other data to illustrate a portion of the work, but not prepared exclusively forthis Contract.K. Samples: Physical examples of products, materials, equipment, assemblies, orworkmanship that are physically identical to a portion of the work, illustrating a portionof the work or establishing standards for evaluating the appearance of the finished workor both.L. Administrative submittals: Data presented for reviews and approval to ensure that theadministrative requirements of the project are adequately met but not to ensure directlythat the work is in accordance with the design concept and in compliance with theContract documents.1.07 SUBMITTAL CLASSIFICATION:Submittals are classified as follows:A. GOVERNMENT APPROVED:Governmental approval is required for extensions of design, critical materials, deviations,equipment whose compatibility with the entire system must be checked, and other itemsas designated by the Contracting Officer. Within the terms of the Contract Clauseentitled "Specifications and Drawings for Construction," they are considered to be "shopdrawings."B. INFORMATION ONLY:All submittals not requiring Government approval will be for information only. They arenot considered to be "shop drawings" within the terms of the Contract Clause referred toabove.1.08 APPROVED SUBMITTALS:The Contracting Officer's approval of submittals shall not be construed as a complete check, butwill indicate only that the general method of construction, materials, detailing and otherinformation are satisfactory. Approval will not relieve the Contractor of the responsibility for anyerror which may exist, as the Contractor is responsible for dimensions, the design of adequateconnections and details, and the satisfactory construction of all work. After submittals have beenapproved by the Contracting Officer, no resubmittal for the purpose of substituting materials orequipment will be considered unless accompanied by an explanation of why a substitution isnecessary.1.09 DISAPPROVED SUBMITTALS:01300-4