specifications - FAACO - Federal Aviation Administration Contract ...

C. WIRE AND CABLE MARKERS:FTWIC-2235June 2009Cloth markers, split sleeve or tubing type.PART 3.00EXECUTION3.01 PREPARATION:A. Degrease and clean surface to receive nameplates or tape labels.B. Install nameplates or tape labels parallel to equipment lines.C. Secure nameplates to equipment fronts using screws, rivets, or adhesive. Securenameplate to inside face of recessed panelboard doors in finished locations.D. Use embossed tape only for identification of individual wall switches and receptacles.3.02 INSTALLATION:A. Provide wire markers on each conductor in panelboard gutters, pull boxes, and at loadconnection. Identify with branch circuit or feeder number for power and lighting circuits,and with control wires number as indicated on equipment manufacturer's shop drawingsfor control and security wiring.B. Provide nameplates to identify all electrical distribution and control equipment, and loadsserved. letter Height: 1/8 inch for individual switches and loads served, and 3/8 inch fordistribution and control equipment identification.C. Panelboards, Switchboards and Motor Control Centers: 3/8 inch; identify equipmentdesignation. 1/4 inch; identify voltage rating and source.D. Individual Circuit Breakers, Switches, and Motor Starters: 3/8 inch; identify circuit andload served, including location.E. Individual Circuit Breakers, Enclosed Switches, and Motor Starters: 3/8 inch; identifyload served.F. Transformers: 3/8 inch; identify equipment designation. 3/8 inch; identify primary andsecondary voltages, primary source, and secondary load and location.G. Color code conduits using colored tape or paint to identify the following systems:1. 480 Volt, Three Phase System: Orange.2. 208 Volt, Single and Three Phase Systems: Yellow3. Fire Alarm System: Red.4. Motor and Other Control Systems: White5. Telephone System: Blue6. Security and Survelliance System: PurpleEND OF SECTION16195-2