specifications - FAACO - Federal Aviation Administration Contract ...

16150 ELECTRICAL EQUIPMENTFTWIC-2235June 2009PART 1.00GENERAL1.01 GENERAL:Furnish labor, materials, equipment and incidentals necessary to complete the work in thissection.1.02 RELATED WORK COVERED ELSEWHERE:General Requirements for Electrical Work Section 160101.03 SUBMITTALS:Submittals shall be in accordance with Section 01300, SUBMITTALS and shall includemanufacturer's data: Submit copies of the manufacturer's specifications and catalog cuts forproducts to be used. Submit complete shop drawings for motorized safe operator.1.04 STANDARDS:Refer to Section 16010, GENERAL REQUIREMENTS FOR ELECTRICAL WORK, for allstandards which apply to this section.PART 2.00PRODUCTS2.01 MANUFACTURED PRODUCTS:A. CONTROL RELAYS:Industrial-type, 600 volt rated with 120 Volts operating coil; contacts shall be rated 10amperes inductive at 120 VAC. Relays shall be manufactured in accordance with NEMAStandards.B. CONTROL STATIONS, INDICATING LIGHTS, SWITCHES AND PUSHBUTTONS:Heavy duty and oil tight; individually mounted devices installed outdoors shall beNEMA 4X enclosures. Devices installed in enclosures other than control stations shallmatch or exceed the rating of the enclosure.C. MOTOR STARTING DELAY TIMERS:Operating voltage to match motor starting coil voltage. Timers shall be installed in thestarting circuit of each motor 5 Hp and above which has the capacity of receiving powerfrom the emergency generators. Timers shall have a maximum range of one hour withincremental settings in minutes. Timers shall have both normally open and normallyclosed contacts.16150-1