specifications - FAACO - Federal Aviation Administration Contract ...

FTWIC-2235June 2009ganged face plates where more than one dimmer is indicated. Coordinate color withArchitectural Finishes.G. PLUG MOLD:Surface mounted 120 volt receptacle strips with 15ampere rated duplex receptaclemounted on 6 inch centers. Coordinate color with Architectural Finishes.PART 3.00EXECUTION3.01 PREPARATION:A. Verify that outlet boxes are installed at the proper height.B. Verify that wall openings are neatly cut and will be completely covered by wall plates.C. Verify that branch circuit wiring installation is completed, tested, and ready forconnection to wiring devices.D. Provide extension rings to bring outlet boxes flush with finished surface.3.02 INSTALLATION:A. Install receptacles and switches only in electrical boxes which are clean, free from excessbuilding materials, dirt and debris.B. Install switches, wall-mounted duplex receptacles and telephone outlets at the heightsspecified in Section 16130, OUTLET BOXES, unless indicated otherwise on the plans.C. Switches installed at one location shall be ganged together under one cover plate.D. Install products in accordance with manufacturer's instructions.E. Install devices plumb and level.F. Install switches with OFF position down.G. Install wall dimmers to achieve full rating specified and indicated after derating forganging as instructed by the manufacturer.H. Install receptacles with grounding pole on top.I. Do not share neutral conductor on load side of dimmers.J. Connect wiring device grounding terminal to branch circuit equipment groundingconductor.K. Connect wiring devices by wrapping conductor around screw terminal and tighten thescrew.16140-3