specifications - FAACO - Federal Aviation Administration Contract ...

16131 PULL AND JUNCTION BOXESFTWIC-2235June 2009PART 1.00GENERAL1.01 WORK INCLUDED:Furnish labor, materials, equipment and incidentals necessary to install pull and junction boxes.1.02 RELATED WORK SHOWN ELSEWHERE:Identifying Systems Section 01080Painting Section 09901General Requirements for Electrical Work Section 16010Conduits Section 161111.03 QUALITY ASSURANCE:Acceptable manufacturers shall be firms regularly engaged in the design, manufacture, andtesting of electrical equipment and shall have been producing electrical sheet metal products forat least five (5) years.1.04 SUBMITTALS:Submittals shall be in accordance with Section 01300, SUBMITTALS, and shall includemanufacturer's data: Submit copies of the manufacturer's specifications and catalog cuts forproducts to be used.1.05 STANDARDS:Refer to Section 16010, GENERAL REQUIREMENTS FOR ELECTRICAL WORK, for allstandards which apply to this section.PART 2.00PRODUCTS2.01 MANUFACTURED PRODUCTS:A. GENERAL:Pull boxes and junction boxes used on concealed runs of conduit in walls and overceilings shall be of code gauge galvanized steel with sheet steel covers. Pull boxes infloors shall be of galvanized malleable cast iron, with gasketed covers. Exposed pullboxes or junction boxes installed outdoors, per NEMA 250 shall be weatherproof andshall be provided with watertight gasketed covers fastened with stainless steel screws.B. PULL AND JUNCTION BOXES:Metal construction conforming to National Electrical Code and ANSI/NEMA OS 1 withscrew-on or hinged cover. Provide hinge type for sheet metal boxes of 12" inches in anydimension.16131-1