specifications - FAACO - Federal Aviation Administration Contract ...

16115 WIREWAYSFTWIC-2235June 2009PART 1.00GENERAL1.01 WORK INCLUDED:Furnish labor, materials, equipment and incidentals necessary to install a complete wirewaysystem.1.02 RELATED WORK COVERED ELSEWHERE:Conduits Section 16111Cable Tray Section 16114Supporting Devices Section 161901.03 SUBMITTALS:Submittals shall be in accordance with Section 01300, SUBMITTALS and shall include wirewaysections, fittings, and connective devices.1.04 STANDARDS:Refer to Section 16010 GENERAL REQUIREMENTS FOR ELECTRICAL WORK for allstandards which apply to this section.PART 2.00PRODUCTS2.01 MANUFACTURED PRODUCTS:WIREWAY:Constructed from no less than 16-gage sheet steel and have cross sectional dimensions not lessthan four inches by four inches. Wireways shall be complete with end closures, supports, andassociated fittings, having the form and dimension suited to the application.PART 3.00EXECUTION3.01 INSTALLATION:A. Provide systems of wireways of sufficient size where indicated. Provide wireways forequipment racks and locations with two or more starters, disconnect switches, or cabinetsmounted in close proximity.B. Size wireway cross-sectional area and length based upon conductor fill and equipmentserved as required by NEC and local codes.C. Install types based on environmental conditions to which exposed. Field apply a 90%zinc paint coating over cuts or scratches before any other finish is applied. Securelyground raceway and fittings. Provide bushings at raceway entrances.16115-1