specifications - FAACO - Federal Aviation Administration Contract ...

16111 CONDUITSFTWIC-2235June 2009PART 1.00GENERAL1.01 WORK INCLUDED:Furnish labor, materials, equipment and incidentals necessary to install a complete conduit systemfor each type of electrical system. Electrical work shall be in accordance with Section 16010,GENERAL REQUIREMENTS FOR ELECTRICAL WORK.1.02 RELATED WORK COVERED ELSEWHERE:Job Management Section 01041Trenching, Backfilling, and Compactingfor Utilities Section 02225Cast-in-Place Concrete Section 03300Flashing and Sheet Metal Section 07600Supporting Devices Section 16190Pull and Junction Boxes Section 161311.03 SUBMITTALS:Submittals shall be in accordance with Section 01300, SUBMITTALS and shall includemanufacturer's specifications and catalog cuts for each type of conduit and fitting to be used.1.04 STANDARDS:Refer to Section 16010, GENERAL REQUIREMENTS FOR ELECTRICAL WORK for allstandards which apply to this section.PART 2.00PRODUCTS2.01 MANUFACTURED PRODUCTS:A. RIGID CONDUIT:Heavy wall, mild steel tube with metallic, corrosion-resistant coating on interior andexterior, hot-dipped, galvanized steel, free from defects; manufactured in accordance withFed. Spec. WW-C-581, ANSI C80.1 standards, and UL listed.B. PVC-COATED RIGID STEEL:Meeting the requirements of rigid steel conduit; 40 mil PVC, exterior coating and redurethane, interior coating.C. ELECTRIC METALLIC TUBING (EMT):Welded steel tubing, formed of low carbon steel, electro-galvanized exterior, insidecoated with a baked, elastic low-friction coating of enamel, in accordance with Fed. Spec.WW-C-563, ANSI C80.3 and UL listed. EMT shall not be used in circuits above 60016111-1 FTWIC-2034