specifications - FAACO - Federal Aviation Administration Contract ...

.FTWIC-2235June 2009switch) is a possible cause of noise in electronic equipment and shall becorrected.6. After the interior wiring system installation is completed, and at such time as theContracting Officer may direct, the Contractor shall conduct an operating test forapproval. The equipment shall be demonstrated to operate in accordance withthe requirements of this specification. The test shall be performed in thepresence of the Contracting Officer or an authorized representative. TheContractor shall furnish all instruments and personnel required for the tests, andthe Government will furnish the necessary electric power.7. Insulation and loop testing shall be completed by the Contractor with a 500-voltD.C. resistance measuring instrument.8. The contractor shall provide incoming power with a clockwise phase rotation toserve the facility. Proper rotation shall be demonstrated by the Contractor andwitnessed by the Contracting Officer’s Technical Representative (COTR/RE)prior to the acceptance of the facility. The test shall be conducted with anapproved phase sequence indicator such as Greenlee, Model 5774 “MotorRotation and Phase Sequence Indicator” or approved equal. Test equipment shallhave a calibration date no less than one year from the testing date.3.09 CLEAN AND ADJUST:Remove shipping labels, dirt, paint, grease, and stains from equipment. Remove debris as itaccumulates. Upon completion of work, clean electrical equipment and the entire electricalinstallation so that it is suitable for the Owner's use.END OF SECTION16010-12