specifications - FAACO - Federal Aviation Administration Contract ...

.FTWIC-2235June 2009diagrammatic only, and do not give fully dimensioned locations of various elements ofwork. Determine exact locations from field measurements.C. Should project conditions require any rearrangement of work, or if equipment oraccessories can be installed to a better advantage than the general arrangement of workon the plans, the Contractor may, before proceeding with the work, prepare and submitplans of the proposed rearrangement for the Engineer's review.D. Electrical equipment sizes indicated on the Drawings are based on a particularmanufacturer. It is the responsibility of the Contractor to verify that the equipment heproposes to furnish will fit in the space indicated on the Drawings. Refer to Architecturaland Structural Drawings for building dimensions. Equipment furnished and installedunder other sections of this specification and by the Owner shall be coordinated withequipment furnished and installed under this section.PART 2.00PRODUCTS2.01 MANUFACTURED PRODUCTS:A. Materials and equipment shall conform to respective publications and any otherrequirements specified below. The Contractor shall furnish all materials not specificallyshown on the list of Government-furnished materials as shown in the Invitation for Bidsof the Contract. Materials and equipment, to be acceptable, must comply with allcontract requirements. Materials to be furnished by the Contractor under thisspecification shall be of manufacturer's regularly engaged in the production of suchmaterials and of the manufacturer's latest designs that comply with the specificationrequirements.B. All structural and miscellaneous steel used in connection with electrical work and locatedout-of-doors or in damp locations shall be hot-dip galvanized unless otherwise specified.Included are underground steel pull box covers and similar electrical items. Galvanizingshall average 2.0 ounce per square foot and shall conform to ASTM A123.C. The Contractor shall provide all special servicing tools required for equipment providedunder this section.D. Approval of materials and equipment will be based on the manufacturer's printed data.The label or listing of Underwriter's Laboratories, Inc., will be accepted as evidence thatthe materials or equipment conform to the applicable standards of that agency. In lieu ofthis listing, the Contractor may submit a statement from a nationally recognized,adequately equipped testing agency indicating that the items have been tested inaccordance with required procedures of the Underwriter's Laboratories, Inc., and that thematerials and equipment comply with all Contract requirements. A manufacturer'sstatement indicating complete compliance with the applicable Federal Specification,Military Specification, or Standard of the American Society for Testing and Materials,National Electrical Manufacturers Association, or other commercial standard, will beacceptable as proof of such compliance.16010-7