specifications - FAACO - Federal Aviation Administration Contract ...

.FTWIC-2235June 20091.04 SUBMITTALS:Submittals shall be in accordance with Section 01300, SUBMITTALS and shall include:A. Component catalog number and manufacturing data sheet, indicating pertinent data andidentifying each component by the item number and nomenclature as specified.B. Component drawings showing dimensions, mounting, and external connection details.C. Complete control schematics and point to point wiring diagrams for the followingsystems:1. Fire Alarm and Detection System2. Security Access System3. Video Surveillance System4. Motor Controls5. Central Vacuum System6. Gate ControllerD. Unless other additional information is required by the detailed equipment specifications,the following information shall be included for motors:1. Motor identification number and nomenclature as specified.2. Make and motor type.3. Brake horsepower of the motor.4. Locked rotor current at full load.5. Motor efficiency at full load (three (3) phase motors only).6. Starting torque.7. Method of insulating and impregnating motor coils (three (3) phases only).8. Speed of the motor at full torque.9. Full load current.10. Service factor.11. Motor temperature rise measured by resistance over 40 degrees C ambient.E. Within 30 days after award of the Contract and before orders are placed or shop drawingsare submitted, the Contractor shall submit to the Contracting Officer a list of equipmentand principal materials specified. Give names of manufacturers, catalog and modelnumbers, and such other supplementary information as necessary for identification.F. Shop drawings shall be submitted for equipment not completely identifiable byinformation submitted on the materials and equipment lists, and whenever requested bythe Contracting Officer. Shop Drawings shall be submitted for but not limited topanelboards, transformers, individual motor starters, cabinets, lighting fixtures, specialpurpose receptacles, and circuit breakers. Shop Drawings shall include: general assemblyand construction details of the equipment, elevations, height, width, depth, bus andphasing arrangement, material identification, and wiring diagrams. All protective devicesshall be sized in accordance with the short circuit calculations and protective coordination16010-2