specifications - FAACO - Federal Aviation Administration Contract ...

E. TOWEL DISPENSER/SURFACE MOUNTED:FTWIC-2235June, 200922 gauge or heavier Type 304 stainless steel with satin finish, having continuous pianohinge and tumbler lock, provided with visible towel level refill indicator, and designed todispense multifold towels. Bobrick model B-262 or approved equal.F. TOILET SEAT COVER DISPENSER/SURFACE MOUNTED:18-8, type 304, 22 gauge stainless steel, satin finish, all welded construction designed todispense standard single-fold or half-fold toilet seat covers. Bobrick model B-221 orapproved equal.G. GRAB BARS:The bars listed below shall be fabricated to meet the following requirements: Stainlesssteel tubing, type 304, No. 4 finish, 18 gauge or heavier, 1-1/2 inch outside diameter,having concealed type fastening at each support. Designed for 1 1/2 inch clearance fromadjacent vertical surface. Bars, when mounted on the scheduled surface, shall be capableof supporting a 300 pound load. Provide fastenings and mounting accessories necessaryto accomplish this requirement. Bends in bars shall be by the mandrel process to assureuniform diameter at bends.1. Horizontal bar - 42” long. Bobrick model B-6206, 99 x 42 or approved equal.2. Horizontal bar - 36” long. Bobrick model B-6206, 99 x 36 or approved equal.H. NAPKIN DISPOSAL UNIT/SURFACE MOUNT:22 gauge or heavier Type 304 stainless steel, with all-welded construction, satin finish,self-closing door with continuous piano hinge. Removable receptacle equipped withtumbler lock. Bobrick model B-254 or approved equal.I. TOWEL DISPENSER/WASTE RECEPTACLE - SEMIRECESSED:22 gage or heavier type 304 stainless steel with satin finish, 8” deep 4” in-wall depth, 4”projection from wall having a flat vertical surface between dispenser and receptacle,having continuous piano hinges, tumbler locks, a removable metal waste container, anddesigned to dispense multifold towels. Bobrick model B-3944 or approved equal.J. MOP AND BROOM HOLDER:Type 304, 22-gauge satin finish stainless steel. Mop holders are spring-loaded, rubbercams with plated steel retainers. Units are 24 inches long, with 3 spring loaded, rubbercam holders and 36 inches long, with 4 spring loaded, rubber cam holders. Bobrickmodel B-223 or approved equal.10805-3