specifications - FAACO - Federal Aviation Administration Contract ...

More documents

Recommendations

Info

B. ACCESSORIES:FTWIC-2235June, 2009Provide extended flanges, mullion covers and separate sills where indicated, matchingcolor of louver.C. BLANK OFF PANELS:Furnish aluminum blank off panels. Panels shall be one (1") inch thick, insulatedsandwich panels with two (2) layers of aluminum with formed-in-place urethaneinsulation.D. FINISH:Aluminum louvers shall be factory finished after fabrication. Clean thoroughly and treatwith a chromate conversion pretreatment followed by an inhibitive primer. Final coatshall be a baked-on Kynar 500 fluorocarbon polymer coating at a dry film thickness of 1mil. Color to match color of exterior surface in which installed.E. SCREEN FRAMES:Frames for insect screens shall be extruded aluminum with finish to match the color ofthe louver. Frames shall be mitered at corners and shall have provisions for replacing thescreen by removable splines which are forced into retaining grooves. Screens shall bestretched tightly into the frame.PART 3.00EXECUTION3.01 PREPARATION:Louvers will be separated from other materials by coating the back sides of louvers with a heavybodied bituminous paint or with neoprene shims.3.02 INSTALLATION:A. Erect each unit into place and secure with anchors furnished by the manufacturer, or boltinto position using methods best suited to the particular application. Install screens to thesurface of louvers and attach with flat-headed, non-corrosive fasteners which have headsthat match the color of the louver.B. Furnish a screen for each louver section. Screens shall be attached to the inside of thelouver section, using fasteners appropriate for the application. Fasteners shall be stainlesssteel of other non-corrosive materials, and heads shall match the finish of the louver.Each screen to have two screen fabrics; one insect screen fabric and one bird screenfabric.C. Provide anchor as shown on the shop drawings. Anchor may be buck anchors, extrudedstraps, aluminum angles or other suitable types. Provide expansion bolts were required.Jambs shall be fastened with not less than three anchors per side, or at a spacing notexceeding 36", whichever is less.10240-3
3.03 CLEAN AND ADJUST:FTWIC-2235June, 2009Clean surfaces of louvers and remove dirt, grease or oil. Patch scuff marks with special touch-uppaint which matches the color of the louver and is furnished by the manufacturer.END OF SECTION10240-4
Page 1 and 2:
FTWIC-2235June, 2009U.S. Department
Page 3 and 4:
TABLE OF CONTENTSFTWIC-2235June 200
Page 5 and 6:
THIS PAGE INTENTIONALLY BLANK
Page 7 and 8:
FTWIC-2235June, 2009.facility on da
Page 9 and 10:
THIS PAGE IS INTENTIONALLY BLANK
Page 11 and 12:
FTWIC-2235June, 2009G. Since portio
Page 14 and 15:
01040 PROJECT ADMINISTRATIONFTWIC-2
Page 16 and 17:
FTWIC-2235June, 20093.02 MATERIALS
Page 18 and 19:
01041 JOB MANAGEMENTFTWIC-2235June,
Page 20 and 21:
3.05 MAINTENANCE OF WATER:FTWIC-223
Page 22 and 23:
Page 24 and 25:
FTWIC-2235June, 2009.1.04 SAMPLES:A
Page 26:
FTWIC-2235June, 2009.I. Shop drawin
Page 29 and 30:
7. Product identification and locat
Page 31 and 32:
FTWIC-2235June, 2009.describe the w
Page 33 and 34:
DEPARTMENT OF TRANSPORTATIONFEDERAL
Page 35 and 36:
Page 37 and 38:
PART 3.00EXECUTIONFTWIC-2235June, 2
Page 39 and 40:
01700 CONTRACT CLOSEOUTFTWIC-2235Ju
Page 41 and 42:
FTWIC-2235June, 2009C. EQUIPMENT WA
Page 43 and 44:
01710 CLEANINGFTWIC-2235June, 2009P
Page 45 and 46:
FTWIC-2235June, 2009G. Clean all pl
Page 47 and 48:
01730 OPERATIONAL AND MAINTENANCE M
Page 49 and 50:
FTWIC-2235June, 2009B. Index sheet
Page 51 and 52:
E. AS-BUILT DRAWINGS:FTWIC-2235June
Page 53 and 54:
J. COLOR AND PATTERNS:FTWIC-2235Jun
Page 55 and 56:
02100 SITE PREPARATIONFTWIC-2235Jun
Page 57 and 58:
03300 CAST-IN-PLACE CONCRETEFTWIC-2
Page 59 and 60:
FTWIC-2235June, 2009water-cement ra
Page 61 and 62:
2. SLUMP TEST:FTWIC-2235June, 2009S
Page 63 and 64:
ASTM C-39ASTM C-42ASTM C-87ASTM C-9
Page 65 and 66:
ACI 305RACI 306RACI 308ACI 309ACI 3
Page 67 and 68:
Concrete TemperatureFTWIC-2235June,
Page 69 and 70:
E. WATER:FTWIC-2235June, 20091. Cle
Page 71 and 72:
FTWIC-2235June, 2009provide a film
Page 73 and 74:
U. ZINC CHROMATE PRIMER:FTWIC-2235J
Page 75 and 76:
FTWIC-2235June, 2009be interpreted
Page 77 and 78:
FTWIC-2235June, 2009plastic layer b
Page 79 and 80:
FTWIC-2235June, 2009L. Clean the su
Page 81 and 82:
FTWIC-2235June, 2009During periods
Page 83 and 84:
3.18 ALUMINUM OR STEEL IN CONTACT W
Page 85 and 86:
FTWIC-2235June, 2009completely fill
Page 87 and 88:
05500 MISCELLANEOUS METALSFTWIC-223
Page 89 and 90:
F. AMERICAN WELDING SOCIETY (AWS) S
Page 91 and 92:
3003 Sheet, tube or pipe5005 Genera
Page 93 and 94:
FTWIC-2235June, 2009exterior concre
Page 95 and 96:
2.07 ARCHITECTURAL EXPANSION JOINT
Page 97 and 98:
G. WINDOW SILL:FTWIC-2235June, 2009
Page 99 and 100:
B. Generally use the following fast
Page 101 and 102:
07921 CAULKING AND SEALANTSFTWIC-22
Page 103 and 104:
H. SEALANT, POLYURETHANE:FTWIC-2235
Page 105 and 106:
FTWIC-2235June, 2009caulking with a
Page 107 and 108:
08110 METAL DOORS AND FRAMESFTWIC-2
Page 109 and 110:
FTWIC-2235June, 20093. Ship door fr
Page 111 and 112:
Page 113 and 114:
1.04 SUBMITTALS:FTWIC-2235June, 200
Page 115 and 116:
FTWIC-2235June, 2009101. Fire hardw
Page 117 and 118: FTWIC-2235June, 2009Square face, sq
Page 119 and 120: FTWIC-2235June, 2009C. Adjust and c
Page 121 and 122: THIS PAGE IS INTENTIONALLY BLANK.
Page 123 and 124: PART 2.00PRODUCTSFTWIC-2235June, 20
Page 125 and 126: FTWIC-2235June, 20093. Sound Seals
Page 127 and 128: 09260 DRYWALL CONSTRUCTIONFTWIC-223
Page 129 and 130: FTWIC-2235June, 2009E. Cooperate wi
Page 131 and 132: 2.02 SOUND ATTENUATION INSULATION:F
Page 133 and 134: 3.05 SUSPENDED CEILINGS:FTWIC-2235J
Page 135 and 136: FTWIC-2235June, 2009utility holes w
Page 137 and 138: 09509 ACOUSTICAL CEILINGS AND SUSPE
Page 139 and 140: FTWIC-2235June, 20091.06 DELIVERY,H
Page 141 and 142: FTWIC-2235June, 20093.03 FIELD QUAL
Page 143 and 144: 09661 RESILIENT FLOORINGFTWIC-2235J
Page 145 and 146: FTWIC-2235June, 2009H. FINISH:A non
Page 147 and 148: THIS PAGE IS INTENTIONALLY BLANK
Page 149 and 150: PART 2.00PRODUCTSFTWIC-2235June, 20
Page 151 and 152: FTWIC-2235June, 2009THIS PAGE IS IN
Page 153 and 154: B. Product data sheets for each pai
Page 155 and 156: 2.02 COLORS AND TINTS:FTWIC-2235Jun
Page 157 and 158: FTWIC-2235June, 2009applying water-
Page 159 and 160: PAINT SCHEDULEFTWIC-2235June, 2009P
Page 161 and 162: FTWIC - 2235June 2009SECTION 099113
Page 163 and 164: FTWIC - 2235June 2009A. Examine sub
Page 167: 1.07 JOB CONDITIONS:FTWIC-2235June,
Page 171 and 172: 10281 BUILDING SPECIALTIESFTWIC-223
Page 173 and 174: FTWIC-2235June, 20092.05 CHANGING B
Page 177 and 178: FTWIC-2235June, 2009PART 2.00PRODUC
Page 179 and 180: K. TOWEL DISPENSER / WASTE RECEPTAC
Page 181 and 182: THIS PAGE IS INTENTIONALLY BLANKFTW
Page 183 and 184: .FTWIC-2235June 20091.04 SUBMITTALS
Page 185 and 186: 1.05 STANDARDS:.FTWIC-2235June 2009
Page 187 and 188: .FTWIC-2235June 2009WW-C-581 Condui
Page 189 and 190: .FTWIC-2235June 2009PART 3.00EXECUT
Page 191 and 192: .FTWIC-2235June 2009B. Use laminate
Page 193 and 194: .FTWIC-2235June 2009switch) is a po
Page 195 and 196: .FTWIC-2235June 2009ATTACHMENT 2Mot
Page 197 and 198: 16111 CONDUITSFTWIC-2235June 2009PA
Page 199 and 200: K. HUBS:FTWIC-2235June 2009FOR USE
Page 201 and 202: FTWIC-2235June 2009I. Route and sus
Page 203 and 204: FTWIC-2235June 2009location and dep
Page 205 and 206: 16115 WIREWAYSFTWIC-2235June 2009PA
Page 207 and 208: 16120 600 VOLT WIRES AND CABLESFTWI
Page 209 and 210: FTWIC-2235June 2009F. The Contracto
Page 213 and 214: E. GROUNDING CONNECTIONSFTWIC-2235J
Page 215 and 216: THIS PAGE IS INTENTIONALLY BLANKFTW
Page 217 and 218: FTWIC-2235June 2009C. CAST BOXES:Ca
Page 219 and 220:
THIS PAGE INTENTIONALLY BLANKFTWIC-
Page 221 and 222:
FTWIC-2235June 2009C. FLUSH-MOUNTED
Page 223 and 224:
16140 WIRING DEVICESFTWIC-2235June
Page 225 and 226:
FTWIC-2235June 2009ganged face plat
Page 227 and 228:
Page 229 and 230:
D. EXHAUST FAN THERMOSTAT:FTWIC-223
Page 231 and 232:
THIS PAGE IS INTENTIONALLY BLANKFTW
Page 233 and 234:
PART 2.00PRODUCTSFTWIC-2235June 200
Page 235 and 236:
PART 3.00EXECUTIONFTWIC-2235June 20
Page 237 and 238:
16170 DISCONNECTSFTWIC-2235June 200
Page 239 and 240:
Page 241 and 242:
PART 3.00EXECUTIONFTWIC-2235June 20
Page 243 and 244:
16190 SUPPORTING DEVICESFTWIC-2235J
Page 245 and 246:
FTWIC-2235June 2009L. Do not suppor
Page 247 and 248:
16195 ELECTRICAL IDENTIFICATIONFTWI
Page 249 and 250:
Page 251 and 252:
B. GROUND CABLES:FTWIC-2235June 200
Page 253 and 254:
FTWIC-2235June 20098. INTERCONNECTI
Page 255 and 256:
FTWIC-2235June 2009In highly humid
Page 257 and 258:
THIS PAGE IS INTENTIONALLY BLANKFTW
Page 259 and 260:
PART 2.00PRODUCTSFTWIC-2235June 200
Page 261 and 262:
FTWIC-2235June 20093.02 FIELD QUALI
Page 263 and 264:
16670 LIGHTNING PROTECTIONFTWIC-223
Page 265 and 266:
FTWIC-2235June 2009and UL 96A. Air
Page 267 and 268:
APPENDIX “A”
show all

specifications - FAACO - Federal Aviation Administration Contract ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?