specifications - FAACO - Federal Aviation Administration Contract ...

FTWIC-2235June, 2009D. Install rubber bases to fit snugly against vertical surfaces. Use caution to avoid smearingadhesive on surfaces other than those receiving the base. Where bases terminate at visiblelocations, install a pre-molded end stop of a matching color. Miter inside corners.3.03 PATTERNS:Where floor patterns are indicated, layout room dimensions in advance to determine where cuttile should be installed. Cut tile width should never exceed 1/2 the tile dimension. Except where full width border tile is required, cut the tile adjacent to wall.3.04 FIELD QUALITY CONTROL:Completed flooring shall be free of broken or cracked tile or rough cut edges. Joints will be tightwithout evidence of mastic. Base shall have tight joints without gaps.3.05 CLEAN AND ADJUST:When installation is completed, remove excess materials, scraps, trash and debris. Removeadhesive from resilient surfaces. Clean adjacent surfaces. After adhesive has set, apply one (1)coat of wax to vinyl tile and buff with a powered floor polisher.END OF SECTION09661-4