Download - Frank's Hospital Workshop

GUIDO RAYOS X, S.A.18Informs when a failure of the skin probe or if it gets disconnected or outof range. The Alarm will activate the corresponding LED and buzzer.The LCD will display ,* ALARM *SKIN SENSORbeing possible to silence. The Radiant warmer is now out of service. TheRadiant warmer can be used on Air Mode if no any circunstances oralarms avoid it, in case it is absolutely needed switch to Air OperationMode and call to the authorized service engineer.2. LOW TEMPERATUREIs activated when temperature reaches aproximately 1 ºC below the presettemperature (See paragrap II.10 to change preset temperature alarmrange). "LOW" alarm LED will lit and the LCD will display,* ALARM *ST - RH OXto silence acoustic alarm press SILENCE key. If SILENCE was pressedand the alarm conditions remain during a period of ten minutes, the alarmwill be activated again.IMPORTANT: CHECK THE CONDITIONS OF THE PATIENT. CHECK THIERE ISNOT AIR FLOW IN THE WARD. CHECK THE HEAT LAMP IS ON (THEMICROPROCESSOR CONTROLS THE HEATING DEVICES); IF CONTRARY, UNPLUGTHE UNIT FROM THE POWER SOURCE, REMOVE THE PATIENT FROM THERADIANT WARMER AND CALL TO THE AUTHORISED SERVICE ENGINEER.3. HIGH TEMPERATUREIs activated when the temperature reaches aproximately 1 ºC higher thanthe preset temperature (See paragrap II.10 to change preset temperaturealarm range). "HIGH" alarm LED will lit and the LCD will display ,* ALARM *ST + RH OXto silence acoustic alarm press SILENCE key. HEAT lamp will switchoff. If SILENCE was pressed and the alarm conditions remain during aperiod of ten minutes, the alarm will be activated again.Check the conditions of the patient. Check if heat sources are close to theRadiant warmer location, if positive keep them away.If the alarm is still effective, unplug the unit from the power source,remove the patient from the radiant warmer and call to the authorisedservice engineer.MAN-012Sept.00Ed. 1 / Rev. 3NESTOMAT 6050