User manual DAHON CB-E110

Manual abstract:
Hub axle Fork end Overall dimensions of fork end, stand and mudguard stay (Varies depe
Fix thearm clip. securely to the chainstay with the brake Note: When installing the b
screw while holding the clip nut with a 10 mm spanner. 2. SI-2860A Attach the brake ar
clip, and then lightly tighten the clip screw and clip nut to provisionally secure the
screw N JAPA Tightening torque: 2 3 N·m {17 26 in. lbs.} After installing the brake a
protrudes about 2 3 mm from the surface of the clip nut. Clip nut Brake arm Brake a
Technical Service Instructions Brake arm clip Installation of the sprocket to the hu
right side of the hub body. Next, install the Sprocket and secure it in plac
Snap ring CAUTION To avoid serious injuries: 3. Spin the wheel and confirm that the br
correct. If the brakes are used frequently, the hub shell may become hot. Do not touch
you finish riding the bicycle. Hub shell Screw the flange nuts or the toothed washers
axle.
After this, take up the slack in the chain and then tighten the flange nuts or hub n
Note the direction Dust cap Flange nut or toothed washer and hub nut One Holland, Ir
+1-949-951-5003 Driver Flange nut Toothed washer Hub nut CB-E 110 Chainstay 2 3 mm C
Before using the Coaster Brake, check that the brake works properly and that the wh
45 N·m {260 390 in. lbs.} These service instructions explain how to use and maintain t
been used on your new bicycle. For any questions regarding your bicycle or other matter
parts, please contact the place of purchase or the bicycle manufacturer. These servi
paper. Please note: Specifications are subject to change for improvement without notic
Nunspeet, The Netherlands Phone: +31-341-272222 3-77 Oimatsu-cho, Sakai, Osaka 590-857
Shimano Inc. PIT.
SZK..
Your user manual
DAHON CB-E110