CipherLab 5100 Time Attendance Terminal Programmer's Manual

Syntech Information Co., Ltd. 智5100 Time Attendance Programmers Manual3.3.7 Alarm Table3.3.7.1 Set Alarm – NWCommandFormatReturnDescriptionExampleRemarkNWNWssnnhhmmddDONE: The setting is done successfully.NAK: Invalid commandSet alarm:ss: station IDnn: 2 digits for alarm# (range 1~16)hhmm: 4 digits for hour & minute to indicate when the alarm is activateddd: 2 digits for seconds to indicate the duration of the alarm to keep on 00~99NW0103123015: add a new alarm record with alarm ID of 03 and activate at 12:30 and lastfor 15 seconds to the 5100 terminal with station ID of 013.3.7.2 Read Alarm – NRCommand NRFormat NRssnnReturn The settings of the requested alarm# is displayed on the screen.NAK: Invalid commandDescription Read alarm settingsss: station IDnn: 2 digits for alarm# (range 01~16)Example NR0101: return message is 142030The alarm time 01 of station 01 is set at 14:20 with a duration of 30 seconds.Remark3.3.8 Work Shifts Table3.3.8.1 Define Work Shift – DWCommandFormatReturnDescriptionExampleRemarkDWDWssnnHHMMhhmmwDONE: The work shift is set successfully.NAK: Invalid commandDefine a work shift:ss: station IDnn: 2 digits for time zone (range 01~16) of a work shiftHHMM: start-time of the work shifthhmm: end-time of the work shiftw: work shift ID or type, 1 digit from 1~6 to indicate F1~F6DW0105103012305: add a new work shift record with work shift ID of 05 and active shiftF5 between 10:30 to 12:30 to the 5100 terminal with station ID of 013.3.8.2 Read Work Shift – DRCommandFormatDRDRssnn2009.05.18 13