Bipap Pro 2 User Manual - NBN Group

More documents

Recommendations

Info

215.5.1 USING AC POWERComplete the following steps to operate the device using AC power:1. Plug the pronged end of the AC power supply’s cord into an electrical outlet.2. The external AC power supply features a cord retainer to provide strain relieffor the AC power cord. Wrap the cord around the AC power supply’s cordretainer, using the wire tie supplied with your power supply.WARNING:Never plug the AC power supply into an outlet that is controlledby a wall switch.WARNING:Route the wires to avoid tripping.3. Leaving a small amount of slack in the cord, connect the cord on the other sideof the power supply to the power inlet on the device, as shown in Figure 5–8.The power cord has a locking connector. To properly plug in the cord:a. Pull the locking mechanism back.b. Push the connector into place.c. Release the lock.Figure 5–8 Plugging in the AC Power Supply4. Ensure that all connections are secure.NOTE:If you need to disconnect the power cord from the device, slide thelocking connector back before removing the power cord.User Manual
225.5.2 USING DC POWERYou can operate the device on DC power by using the Respironics DC poweradapter accessory (when available). See the DC power adapter instructions formore information.CAUTION:Only use the Respironics DC power adapter available from yourhome care provider. Use of any other system may cause damage tothe device or the vehicle.CAUTION:When DC power is obtained from a vehicle battery, the deviceshould not be used while the vehicle’s engine is running. Damageto the device or the vehicle may occur.User Manual
Page 1 and 2: pro 2- AND -User Manual
Page 4 and 5: CHAPTER 7: DEVICE ALERTS ..........
Page 6 and 7: 5CHAPTER 2: WARNINGS AND CAUTIONSWA
Page 8 and 9: 72.2 CAUTIONS• The device may onl
Page 10 and 11: 9OSARampRise TimeObstructive Sleep
Page 12 and 13: 113.3 SYMBOLSThe symbols shown belo
Page 14 and 15: 13NOTE:Additionally, if an alert oc
Page 16 and 17: 154.4 REAR PANELFigure 4-4 shows th
Page 18 and 19: 173. Attach the filter cap as shown
Page 20 and 21: 19B. If you are using a mask with a
Page 24 and 25: 23CHAPTER 6: OPERATING THE DEVICETh
Page 26 and 27: 253. Put on your mask assembly when
Page 28 and 29: 27Figure 6-7 shows how to navigate
Page 30 and 31: 29NOTE:These screens only display i
Page 32 and 33: 312. To increase or decrease the Fl
Page 34 and 35: 332. You can turn the patient disco
Page 36 and 37: 352. Medium Priority SoundThe mediu
Page 38 and 39: 37CHAPTER 8: TROUBLESHOOTINGThis ch
Page 40 and 41: 39Problem Why It Happened What To D
Page 42 and 43: 41CHAPTER 9: CLEANING AND MAINTENAN
Page 44 and 45: 43CHAPTER 10: ACCESSORIESThere are
Page 46 and 47: 45Fuses:There are no user-replaceab
Page 48 and 49: 47GUIDANCE AND MANUFACTURER’S DEC
Page 50 and 51: 49GUIDANCE AND MANUFACTURER’S DEC
Page 52 and 53: 51LIMITED WARRANTYRespironics, Inc.
Page 54: 1018989JH 1/22/04

Bipap Pro 2 User Manual - NBN Group

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?