Accessory Kit 2 in 19489 - Coopers of Stortford

Accessory Kit 2 in 19489InstructionsPartsStrimmerBrush cutterSpark plug socketDebris guardScrewdriverAllen keyDrive shaft headDrive shaftRubber coverASSEMBLING TO YOUR 2-IN-1 EXTENDABLEREACH PETROL CHAINSAW AND HEDGE TRIMMERWARNINGDisconnect the spark plug from the engine before you proceed with assembly.1. Remove your chainsawor hedge trimmerattachment from thedrive shaft at the jointconnection directlybelow the handle.4. Position the debrisguard directly behindthe drive shaft head andsecure the two bolts onthe debris guard bracketusing the Allen keyprovided.2. Remove the blackrubber cover from yournew drive shaft.3. Connect your new driveshaft in the same jointconnection, making surethe gears interlinkcorrectly (you may needto twist the drive shafta couple of times fordrive shaft to lock intoplace), then tighten theknob bolt on the driveshaft securely.5. Align the holes in thedrive shaft and insertthe 5mm Allen keythrough both holes.Please read this instruction manual thoroughly before starting and ensureyou are familiar with the operation.

MAINTENANCEREPLACING THE STRIMMER LINEWARNINGFor replacement line use - remove the spark plug from the enginebefore you change or make adjustments to the strimmer or brushcutter attachments.Use a diameter of 3 /16in (2.4mm). The spool is capable of holding a line up to27ft (8m) on the 4in head, and 46ft (14m) on the 6in head. Avoid using a largerline as it may cut down the trimming performance. Your accessory kit includes a4in spool housing head and 8m of nylon line.WARNINGFor safety reasons, do not use a metalreinforced line.Pinch the slotted area indicated on the spoolhousing to unhook the bottom cap and twistthe spool head to release.Take out the spool and remove the old line.Hook each end of the line in both slotson the edge of the spool, and then pullthe ends through the eyelets in thehousing. Make sure that the springand the washers are in place.While holding the spool against thehousing, pull the line ends to releasethem from both slots. You don’t wantthe line to be secure in these notcheswhen in use as the line won’t feedthrough when you press the bumpstart button.Line up the slot on the bottom capwith the hook on the housing, pressthe cap against the housing and twistin an anti-clockwise motion to securethe cap to the spool housing.Take your new line andwith both ends in onehand run your other handdown both lines so youreach the middle of theline.Your new line and strimmerattachment is now ready to use.Position the middle of the line in either ofcentre notches in the spool.DISPOSALDispose of all paper, cartons and plastic in accordance with your local recyclingregulations.At the end of the product’s lifespan please dispose of it at an authorisedhousehold waste recycling centre.Wind up the line in the correct direction asindicated on the spool.