Climbing Wall Manual - Entre Prises Climbing Walls

B. Imprint Wall AssemblyThis is a description of the modular assembly system.On each panel a metal Corner Plate is built into each corner. A Corner Bracket is thenbolted to the Corner Plate allowing us to:• Bolt the panels together creating a continuous climbing surface.• Attach the panel surface to the substructure.• Fasten rope attachment anchors to the climbing surface and simultaneously transferclimbing loads to the substructure and primary support.The Corner Brackets are connected to Pinch Pipes, which are attached to Angle Clips,which are attached to the support wall. One horizontal Pinch Pipe and one diagonalPinch Pipe are attached to each set of Corner Brackets. A vertical Pinch Pipe attachesfrom each set of Corner Brackets to the set above it. This structure supports the forcesproduced by it’s own weight, the weight of climbers, and any possible falls in accordancewith specifications and industry standards.Vertical pipeDiagonal pipe anglevaries wit h lengt hImprint panelTyp. lead bolt hanger w/ 3/8"but t on head cap screw, t hrough3/4" stud and corner plate.3/4" stud w/ 3/8" internal threadssecured to corner plate w/ 3/4"nut & lock washer.Horizont al pipeVertical pipeTyp. corner bracketsDETAIL: Typ. Corner Bracket Conn.6