Climbing Wall Manual - Entre Prises Climbing Walls

More documents

Recommendations

Info

C. Lead Climbing And Top Rope AnchorsEntre Prises climbing walls are typically designed for bouldering, top rope and leadclimbing. Check specifications on your wall for any use limitations. Certain safetyprocedures have been used. An explanation of these features is listed below.Bouldering: The climbing wall is designed for a working load of one climber per fivelinear feet of climbing wall. The density of climbing routes may be greater than oneevery five feet; however, no more than the stated number of climbers should be on thewall at any given time.Top-roping: Top rope anchors are typically installed on the top row of Imprint orFreeform panels at any Corner Bracket location where two panels connect. U.I.A.A.approved bolt hangers have been used. The anchor consists of two (2) approved bolthangers attached to two adjacent Corner Brackets using 3/8” Grade 8 button head capbolts. The maximum space between the two hangers is 6”. Only Corner Bracketlocations have anchors! Only Entre Prises personnel may install, relocate, or replace theseanchors.Lead climbing: Imprint and Freeform climbing walls are designed for lead climbing withlead bolt locations spaced at every panel intersection. Lead climbing bolts have beenplaced into Corner Brackets on the climbing wall using Grade 8 bolts. As with Top Ropeanchors, U.I.A.A. approved bolt hangers have been used. A single hanger bolted into theCorner Brackets and vertically spaced every meter is sufficient for lead bolts. Two (2)hangers attached to two adjacent Corner Brackets where two or four panels intersecthave been used for belay and top rope anchors. Only Corner Bracket locations haveanchors! The maximum space between these hangers is 6”. Only Entre Prises personnelmay install, relocate, or replace these anchors.11
III. IMPRINT WALL MAINTENANCEA. Tool KitPrimary Tools3/8” Thread Tap, for clearing threads in panel Hand Hold bolt locations.Tap Handle, (3/8” drive)7/32”Allen Socket, (3/8” drive)5/16” Allen Socket, (3/8” drive)1/2” Bolts and Locknuts, (Spares)Hand Hold Bolts, (Spares)Common Tools Necessary For MaintenanceWD-40 For Hand Hold bolts and Threaded Inserts3/4” Wrench3/8” Ratchet3/4” Socket (3/8” drive)Scrub brush and bucket for cleaning panels and holds.12
Page 1: ClimbingWall ManualProject Name ___
Page 6 and 7: (Imprint Wall System, continued)Spe
Page 8 and 9: (Imprint Wall Assembly, continued)T
Page 10 and 11: II. USING YOUR CLIMBING WALLA. Modu
Page 14 and 15: B. InspectionsNote:A complete inspe
Page 16 and 17: c. Yearly InspectionsTop row Panel
Page 18: VI. WARRANTY INFORMATIONEntre Prise

Climbing Wall Manual - Entre Prises Climbing Walls

Create successful ePaper yourself

Delete template?

Save as template?