TEC Zoning Control System for Stand-Alone and BACnet® MS/TP ...

Table 20: Zone Controller Number ( _____ ) 1LocationDate of OriginalInstallationVAV Damper InletDiameter (Inches)Perimeter Zone?Internal Zone?Type of Reheat(If Installed)Zone Vocation andUseVAV Actuator BrandVAV Actuator ModelCapacity of Reheat(If Installed)1. Use the Zone MAC address for the zone controller number, and repeat this checklist for allother zone controllers in the system.Table 21: Zone Controller ConfigurationZone MAC 1Unocc HTZoneBaud 1Unocc CLGet FromSt-By HTRTC MAC 1St-By CLMenuScroSet TypeC or FTOccTimePIR FuncCal RSLockout 1DeadbandBI1 Heat max 1RehtConf 1 Cool min 1AO2RA/DA Min Pos 1AO2 OALK 1 Max Pos 1BO5 OALK 1 MaxHTPos 1BO5 Time PIHT Wei 1BO5 cont PICL Wei 11. This parameter setting is critical for proper control system operation.Table 22: Zone Controller Number ( _____ ) 1 Commissioning (Part 1 of 2)VAV Damper Actuator Properly Rigged and Verified (Opens and Closes withDemand)?Proper Adjustments of Zone-Side Takeoff Balancing Damper?Proper Balancing of Zone Minimum Position? cfm =Proper Balancing of Zone Maximum Position? cfm =Proper Balancing of Zone Maximum Heat Flowcfm =Position (If Reheat is Used)?Verification of Reheat (If Reheat is Used)Maximum Change in Temperature of Reheat (If Duct Reheat is Used)Critical Parameters Properly Set?Zone MACZoneBaudRTC MACLockout58TEC Zoning Control System for Stand-Alone and BACnet® MS/TP Networked ApplicationsTechnical Bulletin