ABB i-bus® EIB Room thermostat solo®, FM Type: 6124-xx

ABB i-bus ® EIBRoom thermostat solo ® , FMType: 6124-xxParametersThe default setting for the valuesis printed in bold type.Cooling:– Output of control value continuous / switchingFor switching control value:– Control type Two-step control / PWM controlOnly for two-step control:– Hysteresis 0.3 K / 0.5 K / 0.7 K / 1.0 K / 1.5 K / 2 K– Reduction of hysteresis inactive0.2 K/min…0.029 K/min– Cyclic time for automatic inactivesending…every 20 minevery 30 minevery 60 min– Mode of control output normal / invertedOnly for PWM control:– Control parameter by installation typemore detailedOnly if “by installation type” is selected:– Type of cooling Cooling ceiling (5 K/240 min)SplitUnit / convector fan(4 K/90 min)Only if “more detailed” is selected:– Proportional range 1 K / … / 4 K / … / 10 K– Readjust time in min. 0 min / 10 min / … / 90 min / 120 min /… / 240 min– Cyclic time of the switching 3 min / 5 min / 10 min / 15 min /control value20 min / 30 min– PWM cycle is 0% up to an 0 % / 5 % / 10 % / … / 30 %output value– PWM cycle is 100% down to 70 % / … / 90 % / 95 % / 100 %an output value– Mode of control output normal / invertedFor continuous control value:– Control parameter by installation typemore detailedOnly if “by installation type” is selected:– Type of cooling Cooling ceiling (5 K/240 min)SplitUnit / convector fan(4 K/90 min)Only if “more detailed” is selected:– Proportional range 1 K / … / 4 K / … / 10 K– Readjust time in min. 0 min / 10 min / … / 90 min / 120 min /… / 240 min– Minimum control value 0 % / 5 % / 10 % / … / 30 %– Maximum control value 70 % / … / 90 % / 95 % / 100 %– Cyclic time for automatic sending inactiveof control output…every 20 minevery 30 minevery 60 min– Mode of control output normal / inverted2 - 12 March 2003