BCT-2000 Software and BCT-128 and BCT-256 User's Guide - Alber

16. MaintenanceThe BCT-2000 Series test system should provide years of service if properly maintained. Cleanthe laptop computer screen and case using a soft cloth, slightly moistened with water. Do not usecommercial or industrial cleaners that may attack the computer display and housing. Neverexpose the computer or the BCT-128 or BCT-256 to water, high humidity, or dampness.WARNING: Before cleaning any component, ensure the system is disconnected and power to theunit has been shut offSense Leads - Clean the BCT-2000 sense leads after each use. The acid to which the sense leadclips are exposed during testing should be neutralized often, using a water and baking sodamixture. Brush this mixture onto the sense lead clip, then rinse well with clean, cool tap water.When cleaning the sense lead clips with any water or water based solution, ensure the system isdisconnected and power to the unit has been shut off. Dry with a clean, soft cloth.The BCT-2000 is microprocessor based and has no user-replaceable components. Also, becausehigh voltage exists in several areas in each unit, only knowledgeable users should remove thecovers or cowling from devices when required. Failure to comply with this restriction could voidthe system warranty.WARNING: High voltages exist inside the BCT-2000 system components and on the CS-2000terminals. Calibration must be performed only by technically qualified persons. Observeelectrical safety precautions when removing and installing the BCT cover, and when connectingleads and making adjustments.The shipping cases will protect the BCT-2000 from normal bumps and bangs when storedproperly, and will provide protection during shipment between test sites.71