BCT-2000 Software and BCT-128 and BCT-256 User's Guide - Alber

Auto Select - Click Auto Select to automatically select cells that were at or below the lowthreshold level. In auto select mode, you may manually select additional cells for the reportby selecting check boxes in the list. To clear a selection, select the box again. If you laterchange the low cell threshold on the Criteria box, cells that meet the new criteria areautomatically selected, and cells manually selected before the threshold change are notselected.Manual Select - Click the Manual Select button to manually select cells for the report. Addcells to the report by selecting the check boxes. To clear a selection, select the box again.Changing the low cell threshold does not change selected cells when in the manual mode.All On and All Off - Click All On to select all cells in the list. Click All Off to clear all cellselections. You may use this feature in auto or manual mode.13.8. Graph ScreenClick the Graph tab to display the Graph dialog box. The values displayed are 10% below theminimum and 10% above the maximum values found during the test.Figure 39. GraphManual - To change the minimum and maximum values displayed on report graphs, clickManual and select values. The Cell Scaling and OV Scaling values are in volts. Load Scalingis in amps, and Power Scaling is in watts.Auto - If Auto is selected, the graphs are plotted to within 3% of the values.Low Cell Criteria Label and Low OV Criteria Label - You may type new graph names inthese areas for report graphs.47