BCT-2000 Software and BCT-128 and BCT-256 User's Guide - Alber

11.4.6. Recharge TestThe recharge test monitors the battery system while it is being recharged. For every twocell volts, the cell warning level is set to 2.33V. The OV warning levels are a multiple ofthese levels times the number of cells per string. On this test, the levels are high level(maximum) values.Figure 12. Setup - Test Setup: Recharge11.5. Test Setup ParametersThe following items are available on the Test Setup dialog boxes depending on the test typeselected.11.5.1. Rated TimeAvailable for test types: Performance, Modified PerformanceType the manufacturer’s specified rated time in the Rated Time box. This value isimportant for the on-line capacity calculation performed during a single step capacitytest. The format is hh:mm:ss. If doing a Modified Performance test, you may leave RatedTime blank.You may type 0 (zero) for Rated Time on a Modified Performance test. If this is done,the test does not calculate battery capacity at test time. You may enter a Rated Time atreport generation.11.5.2. Power TypeAvailable for test types: Performance, Modified Performance, Service, ChargerConstant Power and Constant Current - To define power type, click Constant Power orConstant Current. Power type determines if the programmed load is rated in watts oramps. The power type selected applies to all steps; you cannot switch between ConstantPower and Constant Current between steps.23