Air inserting tool IP900 FIAM Utensili Pneumatici Spa - Industrial ...

Индастриал Технолоджис www.ind-techno.com.ua +38 044 596 04 291.53.4Type of the toolStrokesStartingsystemWeightDimensions(mm)Compressed airconsumptionAir inletNoise levelModelCodemin.TypeKg.lbØ x lTypedBAIP900 169975110 9000,440 0.97 32x204 < 1 1/4” gas 78LegendLeverStandard equipment (supplied with the tool)• Hanging ring• Use and maintenance manual• Eco-friendly packagingOther technical featuresAccessories available upon request• The figures shown are measured at a pressure of 3,5 bar(ISO 8662-1), the recommended operating pressure.Max operating pressure: 6,3 bar• Noise level has been measured in accordance with ISO 3744 andISO 15744 standards.• The code number must be used when ordering.• Bits for male and female insulated or non-insulated electric connectors with a pitch of 6.35 mm.The data given in the table are indicative and can be changed withoutprior notice. The values indicated for noise are obtained in thelaboratory, performing tests that comply with the standards stated,but alone are not sufficient for calculating risks. Values measured inthe single work places may be higher than those stated. The valuesof actual exposure and consequent risks are specific and depend onthe operator’s method of work, the type of work piece and the workplace, as well as the operator’s time of exposure and his physicalconditions. Fiam cannot be held responsible for any consequencesderiving from the use of the information in the table when evaluatingrisks in the work place over which Fiam has no control. For all furtherdetails, please apply to the Fiam Technical Consultancy Service.Bits for connectors Bits for connectors Bits for connectorsCode 635856010 Code 635856015 Code 635856020Length max 50 mm.Can be used only for male and femalenon-insulated electric connectors.15.381.6Length max 50 mm.Can be used only for male and female insulatedelectric connectors.15.47Length max 51 mm.Can be used only for male and female electricconnectors, both insulated and non-insulated.The special form of the head aids the “guided”insertion of the insulated electric connector.1.65.18.110.25.2July 2011 - 36 | Printed on recycled paper for the safeguard of the environment | Copyright Fiam Spa. The unauthorised distribution and/or reproduction of all or part of this publication is strictly forbidden.Industrial Technologies• On request or according to drawing, special bits can be supplied for every other type of electric connector.Specify the pitch and send a sample.• Bits, hexagonal sockets; balancers, exhaust silencers and other compressed air system accessories: see Accessories catalogue.Fiam Utensili Pneumatici SpaViale Crispi 123 - 36100 Vicenza - ItalyTel. +39.0444.385000Fax +39.0444.385002customerservice@fiamairtools.comwww.fiamairtools.comQuality ManagementSystem CertificateEnvironmental ManagementSystem Certificate