Lambda 20/Lambda 40 Installation and Maintenance Guide - VTP UP

More documents

Recommendations

Info

Lambda 20, Lambda 40 UV/Vis SpectrometersOperating HoursCounterFigure 14 Prealigned Deuterium Lamp Assembly (B2000501)NOTE: An operating hours counter is incorporated in the red deuterium lamp lead.By means of a gap between the two display bars it is possible to read off the numberof hours that the lamp has been in operation.One scale division corresponds to approximately 100 hours.WARNINGElectrical HazardSwitch off the spectrometer and remove the plug from the electricalsupply before starting with the replacement.Risk of BurnsIf the old lamp was lighted: allow it to cool before proceeding with thereplacement.UV RadiationThe lamps emit intense radiation which can damage your eyes.Do not open the lamp compartment when the lamps are on.Do not gaze into a lighted lamp.1. Switch off the spectrometer and unplug the line power cord.2. Remove the lamp compartment cover by pressing down the catch and pushingthe cover to the left.3. Remove the lamp baffle by slackening the thumbscrew for the deuterium lampand lifting the lamp baffle vertically upward.60
MaintenanceLamp baffleThumbscrew(deuterium lamp)4. Unplug the deuterium lamp connector from the terminal board by squeezing inthe two lugs at each side of the connector and carefully pulling the connectorvertically upward.Deuterium lampconnectorDeuterium lampassembly5. Remove the lamp assembly from the bracket by slackening the thumbscrewand pulling the lamp mount vertically upward.Save the thumbscrew for use with the new lamp assembly.61
Page 2:
Release HistoryPart Number Release
Page 5:
Safety Information 1
Page 8 and 9:
Lambda 20, Lambda 40 UV/Vis Spectro
Page 10 and 11: Lambda 20, Lambda 40 UV/Vis Spectro
Page 19 and 20: PrefacePrefaceApplicationThe Lambda
Page 21: Basic Installation 3
Page 24: Lambda 20, Lambda 40 UV/Vis Spectro
Page 39 and 40: Accessory InstallationAccessory Ins
Page 41 and 42: Accessory InstallationJ88, Sphere I
Page 43 and 44: Accessory InstallationLinear Transp
Page 45 and 46: Accessory InstallationMulti-sippers
Page 47 and 48: Accessory InstallationPersonal Comp
Page 49: Maintenance 5
Page 59: Maintenance5. Remove the lamp assem
Page 63 and 64: MaintenanceWARNINGElectrical Hazard
Page 65 and 66: MaintenanceChanging FusesWARNINGEle
Page 67 and 68: Maintenance5. Press 4 Print to feed
Page 69: Replacement Parts 6
Page 75 and 76: System DescriptionSystem Descriptio
Page 77 and 78: System DescriptionHalogenlampM2M =
Page 79 and 80: System DescriptionThe radiation is
Page 81: Technical Data 8
Page 93 and 94: Translations of WarningsTranslation
Page 95 and 96: Translations of Warnings95
Page 103: Index 10
Page 106: Lambda 20, Lambda 40 UV/Vis Spectro
show all

Lambda 20/Lambda 40 Installation and Maintenance Guide - VTP UP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?