Lambda 20/Lambda 40 Installation and Maintenance Guide - VTP UP
Lambda 20/Lambda 40 Installation and Maintenance Guide - VTP UP
Lambda 20/Lambda 40 Installation and Maintenance Guide - VTP UP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Lambda</strong> <strong>20</strong>, <strong>Lambda</strong> <strong>40</strong> UV/Vis SpectrometersInscription legibleon HolderLAMBDABIO LAMBDA 2Use in SpectrometerIn this position, the cell holder can be used with all<strong>Lambda</strong> Series Spectrometers.In this position, the cell holder can be used with <strong>Lambda</strong>2 Series Spectrometers as <strong>Lambda</strong> 10, <strong>20</strong>, <strong>40</strong>, Bio, etc.(baseplate with 4 threaded holes).The smallest beam diameter is exactly in the middle ofthe cell. This is useful especially for operation withmicro <strong>and</strong> semi-micro cells.Installing the Cell HolderInstall the single cell holder in the sample compartment as follows:1. Orientate the holder so that the lifter is toward the rear of the samplecompartment.2. Lower the holder so that the two alignment holes slip onto the two studs on thebaseplate at the bottom of the sample compartment.The arrow on the cell holder must line up with the centre point of the baseplate,<strong>and</strong> BIO LAMBDA 2 must be legible.Tube PortsBIOLAMBDA 2ArrowCenter Point30
Change language