TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1g. Check camshaft bearings:(1) Inspect camshaft bearings for chips, scoring, or cracks. If defective, mark for replacement.(2) Measure inside diameter of each camshaft bearing to determine amount of wear.(3) Mark for replacement if diameter is greater than 2.5008 in. (63.5203 mm).(4) If bearing has turned in block bore (oil hole in bearing not alined with hole in block bore) measure insidediameter of bore with bushing removed. Refer to para 3-6f(35) for bearing removal.(5) Replace cylinder block if inside diameter is greater than 2.6265 in. (66.7131 mm).h. Check block top flatness.(1) Place straightedge on top of block to check flatness from front to rear and left to right.(2) Using a 0.002 in. (0.050 mm) feeler gage, try to insert gage between straightedge and block. If clearancegreater than 0.002 in., top surface must be resurfaced (para 3-9a).3-61