TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1WARNINGHOT TANK CLEANING SOLVENTS ARE POTENTIALLY DANGEROUS. WEARPROTECTIVE CLOTHING AND GOGGLES TO PREVENT SERIOUS PERSONALINJURY.i. Submerge cylinder block in hot agitation tank with water and cleaning solvent solution heated to 180°F-200°F(82°C-93°C). Leave in tank for 12 hours.j. Remove block from hot tank and steam clean to remove loose sludge and deposits.k. Run rods with brushes or swabs through all passages.WARNINGCOMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONALPROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).l. Blow shop air through all passages, ports, and capscrew holes to remove debris.m. Direct shop air through no. 1 cylinder air vent hole which opens to water pump cavity.n. With emery cloth, remove any nicks and burrs from liner upper and lower counterbores.3-59