TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1WARNINGCOMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI(207 KPA) USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONALPROTECTIVE EQUIPMENT (GOGGLES/SHIELD, GLOVES, ETC.).(3) Use clean, dry, compressed air to blow out and dry all tapped holes in castings.d. Oil Passages. Particular attention must be given to all oil passages in castings and machine parts. All oilpassages must be clean and free of obstructions.(1) Clean passages with wire or a probe to break up any sludge or gum deposits.CAUTIONDO NOT ALLOW DRY CLEANING SOLVENTS TO COME IN CONTACT WITH SEALSOR FLEXIBLE HOSES. THESE CLEANERS CAUSE LEATHER, RUBBER ANDSYNTHETIC MATERIALS TO DRY OUT, ROT, AND LOSE PLIABILITY.(2) Wash passages by flushing with dry cleaning solvent.WARNINGCOMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONALPROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).(3) Dry passages by blowing them out with compressed air.e. Oil Seals and Flexible Hoses. Clean seals and flexible hoses with soap and water.f. Ball Bearings.Refer to TM 9-214 for information on care and maintenance of antifriction bearings.3-2