TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1WARNING• COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONALPROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).• P-D-680 SOLVENT IS POTENTIALLY DANGEROUS. AVOID PROLONGED ORREPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVEHEAT.(2) Clean insert bore with solvent and dry with compressed air.CAUTIONUSE NEW PUSH TUBE ANYTIME INSERT IS REPLACED. THIS PRACTICEENSURES PROPER VALVE AND INJECTOR PERFORMANCE.(3) Carefully press new insert into follower lever.(4) Check insert to ensure it is fully seated.c. Repair cam follower housing.NOTERepair limited to removal of sharp edges, nicks, and burrs at shaft entry points.(1) Place small strip of 240 grit aluminum oxide sanding cloth on steel rod, split to accept paper.(2) Clean bore with sanding cloth and rod secured to hand drill.WARNING• COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONALPROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).• P-D-680 SOLVENT IS POTENTIALLY DANGEROUS. AVOID PROLONGED ORREPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVEHEAT.(3) Dip housing in solvent and dry with compressed air.3-221