12.07.2015 Views

TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

TM 9-<strong>2815</strong>-<strong>226</strong>-<strong>34</strong>-1(9) Indications that contain loose or foreign particles or voids left by such particles are not acceptable.(10) Not more than three open indications are to appear on any one journal (15) or crankpin (2). Scatteredsmall, open, or subsurface indications, four per crankpin (2), and six per main bearing (15), 1/8 in. long orless, if not forming part of a long intermittent indication or entering an oil hole (1) or (14), or fillet (4), will notbe counted as indications in arriving at the total number permitted. However, if in addition to showing themaximum number of acceptable indications for the whole crankshaft, the-part also shows many widelyscattered short indications, it must be rejected.(11) An inclusion which is intermittently open and subsurface shall be considered and measured as an openindication after the original indication has been wiped off. The entire modification must first meet therequirements for subsurface limits.(12) Open and subsurface indications on counterweights and crankthrow bevel outside the critical region areacceptable.(13) Open seams on web periphery that show depth on crankpin wall (10) may be removed from web peripherywith a 1/2 in. radius wheel, provided at least 1/16 in. remains above crankpin fillet (6) after repair andbalance limits are maintained.(14) Seams or indications outside the critical region that extend over crank web periphery (21) but are not visibleon the crankpin wall are acceptable.(15) Indications due to weld defects are not acceptable in the counterweight welds. Indications at flank cheekcorner (23) may be ground out and blended to a depth not exceeding 1/4 X 5/8 in. long.(16) Open longitudinal indications in the thrust flange fillets (24) longer than 3/8 in. are not acceptable.(17) Limits of indications on the oil seal surface (11) (which, when wiped clean do not show sharp edges) areacceptable.(18) After inspection where coil shot is used, give crankshaft head shot to put magnetic poles at ends of crank,not throws. The residual magnetic field should not exceed two units on the Magna Flux Field Indication orequal.3-123

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!