TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1e. Measure thrust flange wear at four points 90 degrees apart. If distance between thrust flange and rearcounterweight does not exceed 3.006 in. (76.352 mm), flange wear is acceptable.f. If wear exceeds 3.006 in. (76.352 mm), shaft must be ground to restore flatness.g. If after grinding, dimension does not exceed 3.008 in. (76.403 mm), standard thrust rings may be used.h. If dimension exceeds 3.008 in. (76.403 mm), flange must be reground to accept 0.010 or 0.020 in. (0.254 or 0.508mm) oversize thrust rings, i. Regrinding must clean up a minimum of 90 percent of thrust surface and result inmaintaining installed crankshaft end clearance below 0.015 in. (0.381 mm).LEGEND:1. 51.8125 INCHES 5. 2.000 INCHES 9. 5.998 TO 6.000 INCHES(1316.0375 MM) (50.8 MM) (76.2762 TO 152.4 MM)2. 4.499 TO 4.500 INCHES 6. 2.500 INCHES 10. 5.151 TO 5.163 INCHES(114.2746 TO 114.3 MM) (63.5 MM) (130.8354 TO 131.1402 MM)3. 2.4375 INCHES 7. 2.000 INCHES 11. 0.172R TO 0.195R INCHES(61.9125 MM) (50.8 MM) (4.3688 TO 4.953 MM)4. 2.126 TO 2.128 INCHES 8. 3.001 TO 3.003 INCHES 12. 3.1235 TO 3.12505 INCHES(54.0004 TO 54.0512 MM) (76.2254 TO 76.2762 MM) (79.3369 TO 79.375 MM)j. Measure crankshaft journals and other points of measurement and compare to illustration.3-119