TM9-2815-226-34-1 - JATONKAM35s HOME ON THE WEB

TM 9-2815-226-34-1(5) Add shim(s) beneath liner flange as needed to establish a 0.003 in. (0.076 mm) minimum to 0.006 in.(0.152 mm) maximum protrusion. Shims are available in 0.007, 0.008, 0.009, 0.020, 0.030, and 0.062 in.(0.177, 0.203, 0.228, 0.508, 0.762, and 1.574 mm) sizes.(6) Reinstall liner with appropriate size shims.(7) Reclamp liner and retorque clamp capscrews to 50 ft lbs (68 N•m). Remeasure protrusion to insuredimensions are within specifications.(8) Remove gage block and dial indicator, clamps, and liner.k. Check cylinder liner lower counterbore.(1) Install new liner without shims or seals into cylinder block and clamp liner in position. Torque clampcapscrews to 50 ft lbs (68 N•m).(2) Measure clearance between cylinder block and liner lower counterbore with narrow leaf feeler gage. Linercontact with block is permitted providing it does not cause liner out-of-round.(3) If clearance exceeds 0.006 in. (0.152 mm), remove liner and measure inside diameter of lowercounterbore.(4) If lower counterbore diameter exceeds 6.126 in. (155.600 mm), counterbore must be machined to acceptreplacement sleeve. Sleeve is available in two sizes; 6.2555 in. (158.889 mm) and 6.3055 in. (160.1597mm).3-64