MKLD-MKLF-MKLS - VAHLE, Inc

EXPANSION JOINT SECTIONSincl. 1 m section19 12TypeWeightkgCat.-No.MDD- 6-8 HS 1,890 235 224MDD- 9 HS 1,883 235 225MDD- 10 HS 1,877 235 226MDD- 6-8 SS 1,890 235 227MDD- 9 SS 1,883 235 228MDD- 10 SS 1,877 235 229500Dim. »a« max. 70 mma1000 + a500Expansion section Typ MDD is required to compensate differencein expansion between insulated housing and copper conductors.The expansion joints are used if the Powerail length betweenfeeds, curves, transfer guides and other fix points is exceeding10 m.Max. length to temperature differences∆ t 20° C = 70 m ∆ t 40° C = 35 m ∆ t 80° C = 17 m∆ t 30° C = 45 m ∆ t 60° C = 23 mLonger runs or higher differences in temperature require severalexpansion joints.MKLDAdditional feed points and collectors are not necessary as theconductor rail is not electrically separated.TypeWeightkgCat.-No.MDS- 6/ 40-100 HS 5,400 235 395MDS- 7/ 40-100 HS 5,520 235 396MDS- 8/ 40-100 HS 5,640 235 397MDS- 6/140-200 HS 5,900 235 398MDS- 7/140-200 HS 6,020 235 399MDS- 8/140-200 HS 6,140 235 400MDS- 6/ 40 SS 5,400 235 401MDS- 7/ 40 SS 5,520 235 402MDS- 8/ 40 SS 5,620 235 403»X«500Dim. »a« max. 100 mm»X« see page 2 for finish of endsa1000 + aExpansion joint section Type MDS is required to compensatedifference in expansion between insulated housing and supportingstructure:The expansion joints are used if the powerail length betweenfeeds, curves, transfer guides and other fix points is exceeding20 m.Max. length to temperature differences:∆ t 90° C (–30° C to + 60° C) one expansion joint section per100 m, and so on each 100 m.500»X«MKLFMKLSAdditional feed points and collectors are not necessary as theconductor rail is not electrically separated.15