3820 UG.book - Finn-ID

Intercharacter DelayAn intercharacter delay of up to 495 milliseconds may be placed between thetransmission of each character of scanned data. Scan the Intercharacter Delaybar code below, then scan the number of milliseconds and the SAVE bar codeusing the Programming Chart inside the back cover of this manual.Prefix Scanned Data Suffix1 2 3 4 5Intercharacter DelayIntercharacter DelayTo remove this delay, scan the Intercharacter Delay bar code, then set thenumber of steps to 0. Scan the SAVE bar code using the Programming Chartinside the back cover of this manual.Note: Intercharacter delays are not supported in USB serial emulation.User Specified Intercharacter DelayAn intercharacter delay of up to 495 milliseconds may be placed after thetransmission of a particular character of scanned data. Scan the Delay Lengthbar code below, then scan the number of milliseconds and the SAVE bar codeusing the Programming Chart inside the back cover of this manual.Next, scan the Character to Trigger Delay bar code, then the 2-digit hex valuefor the ASCII character that will trigger the delay ASCII Conversion Chart (CodePage 1252) on page A-2.Delay LengthCharacter to Trigger DelayTo remove this delay, scan the Delay Length bar code, and set the number ofsteps to 0. Scan the SAVE bar code using the Programming Chart inside theback cover of this manual.2020/3820 User’s Guide 4 - 5