3820 UG.book - Finn-ID

ogy and scan the 2 digit hex value from the Programming Chart inside theback cover of this manual.3. LengthSpecify what length (up to 9999 characters) of data output will be acceptablefor this symbology. Scan the four digit data length from the ProgrammingChart inside the back cover of this manual. (Note: 50 characters is enteredas 0050. 9999 is a universal number, indicating all lengths.) When calculatingthe length, you must count any programmed prefixes, suffixes, or formattedcharacters as part of the length (unless using 9999).4. Character Match SequencesOn the ASCII Conversion Chart (Code Page 1252) on page A-2, find the Hexvalue that represents the character(s) you want to match. Use the ProgrammingChart inside the back cover of this manual to read the alphanumericcombination that represents the ASCII characters. (99 is the Universal number,indicating all characters.)5. End Output Sequence EditorScan F F to enter an Output Sequence for an additional symbology, or Saveto save your entries.Other Programming Selections•DiscardThis exits without saving any Output Sequence changes.Output Sequence EditorEnter SequenceDefault SequenceRequire Output SequenceWhen an output sequence is Required, all output data must conform to an editedsequence or the scanner will not transmit the output data to the host device.When it’s On/Not Required, the scanner will attempt to get the output data toconform to an edited sequence, but if it cannot, the scanner transmits all outputdata to the host device as is.When the output sequence is Off, the bar code data is output to the host as thescanner decodes it.2020/3820 User’s Guide 3 - 9