3820 UG.book - Finn-ID

Automatic Direct Connect Mode: This selection can be used if you have anIBM AT style terminal and the system is dropping characters. Default = OffAutomatic DirectConnect Mode OnConnecting the Base with RS-232 Serial Port1. Turn off power to the terminal/computer.2. Connect the appropriate interface cable to the base.* Automatic Direct ConnectMode OffNote: For the base to work properly, you must have the correct cable for yourtype of terminal/computer.42353. Plug the serial connector into the serial port on your computer. Tighten thetwo screws to secure the connector to the port.4. Plug the power supply barrel connector to the base, and plug the powersupply into the AC source.5. Once the base has been fully connected, power up the computer.2 - 8 2020/3820 User’s Guide