3820 UG.book - Finn-ID

Using the Scanner with Bluetooth DevicesThe 3820 scanner may be used either with the 2020-5B base or with otherBluetooth devices. Scanning the Non-Base Bluetooth Connection bar codebelow allows the scanner to be used with other Bluetooth devices (e.g., PDA, PC- Bluetooth USB Adapter). After you scan the bar code below, follow theinstructions supplied with your Bluetooth device to locate the scanner andconnect to it. If you go out of range with your scanner, the scanner automaticallyreconnects to the Bluetooth device. If you want to relink to the 2020-5B base,refer to "Single Scanner Operation" on page 1-7 or "Multiple ScannerOperation" on page 1-8.Note: The multiple work groups option is not available when you are using theimager with Bluetooth devices other than the 2020-5B base.Non-Base BT ConnectionChanging Bluetooth PIN CodeSome devices require a PIN code as part of the Bluetooth security features. Yourscanner’s default PIN is 1234, which you may need to enter the first time youconnect to your PDA or PC. The PIN code must be between 1 and 16 characters.To change the PIN, scan the bar code below and then scan the appropriatenumeric bar codes from the Programming Chart inside the back cover of thismanual. Scan Save to save your selection.Bluetooth PINOut-of-Range AlarmDurationIf your scanner is out range of the base, an alarm sounds from both your baseand scanner. To activate the alarm options for the scanner or the base and toset the alarm duration, scan the appropriate bar code below and then set thetime-out duration (from 0-3000 seconds) by scanning digits on the ProgrammingChart inside the back cover, then scanning Save. Default = 0 sec (no alarm).Base Alarm DurationScanner Alarm Duration2020/3820 User’s Guide 1 - 13