3820 UG.book - Finn-ID

Resetting the Standard Product Default Settings:Current Application Work GroupIf you aren’t sure what programming options are in your scanner, or you’vechanged some options and want the standard product default settings restored,scan the Standard Product Default Settings: Current Application Group barcode below.The Menu Commands starting on page 10-6 list the factory default settings foreach of the commands (indicated by an asterisk (*) on the programming pages).Note: Scanning this bar code also causes both the scanner and the base toperform a reset and become unlinked. Refer to "Linking Scanner toBase" on page 1-6 for additional information.Standard Product Default Settings:Current Application GroupNote: If your scanner is in multiple scanner mode and you scan either thecurrent or all application group default bar code, you will hear up to 30seconds of beeping while all scanners are re-linked from the base and thesettings are defaulted to * settings. The default interface is keyboardwedge and the default scanner mode is single scanner locked link mode.Resetting the Standard Product Default Settings: AllApplication Work GroupsThe following bar code defaults all of the work groups to the factory settings.Standard Product Default Settings:All Application GroupsThe Menu Commands starting on page 10-6 list the standard product defaultsettings for each of the commands (indicated by an asterisk (*) on theprogramming pages).1 - 12 2020/3820 User’s Guide