3820 UG.book - Finn-ID

Linking Scanner to BaseWhen newly shipped or defaulted to factory settings, the base and scanner arenot linked. Once the scanner is placed into the base, the software automaticallylinks the scanner and the base. If the scanner and base have previously beenlinked, you do not receive any feedback. If this is the first time that the scannerand base are linked, both devices emit a short chirp when their radios link. Atthis point, you are set to one scanner to one base.3820 ScannerGreen LEDRed LED2020-5B Cordless Base1. Provide power to the base.2. Place the 3820 into the base. The scanner and base link.3. To determine if your cordless system is set up correctly, scan one of thesample bar codes in the back of this manual. If the scanner provides asingle good read beep and the green LED lights, the scanner hassuccessfully linked to the base. If you receive a triple error beep and the redLED lights, the scanner has not linked to the base.Scanner ModesThe 3820 is capable of working in single scanner mode, multiple scanner mode,or with Blutetooth devices, other than the 2020-5B base.Unlinking the ScannerIf the base has a scanner linked to it, that scanner must be unlinked before a newscanner can be linked. Once the previous scanner is unlinked, it will no longercommunicate with the base. To unlink a scanner from the base, scan the UnlinkScanner bar code below.Unlink Scanner1 - 6 2020/3820 User’s Guide