SkyView System Installation Guide - Dynon Avionics

SV-ADAHRS-20X Installation and Configuration3. Feed the nylon washer over the body of the probe.4. Hand-thread the nylon nut onto the threaded body of the probe. At this point, the nylonwasher should be sandwiched between the nylon nut and the inside of the fuselage.5. Carefully tighten the nut using the 9/16” wrench.6. Route and secure the probe wires to the location of the ADAHRS module. Keep wiresaway from radios, ignition, and other noisy electronics.7. Carefully insert the pins on the wires into the connector housing. Pins are not polarizedand lock into place when inserted correctly.8. Connect the probe to the ADAHRS module.If the OAT probe is installed correctly, there should be an outside air temperature reading onthe PFD.Adjusting OAT OffsetSkyView provides the ability to adjust the displayed OAT +/- 20F (11.1C). This adjustment isapplied across the OAT’s entire temperature range. This adjustment can be made under SETUPMENU >HARDWARE CALIBRATION > ADAHRS CALIBRATION > OAT OFFSET.Dynon D10/D100 Series OAT ProbesIf your aircraft already has a Dynon Avionics OAT installed from an older Dynon Avionicsproduct, and you do not want to reinstall the SV-OAT-340 in its place (difficult access, etc.), it ispossible to use the older OAT with SkyView. Cut off as much wire as needed from the SV-OAT-340 - you will use the White w/Black wires with pins pre-crimped, and the connector.If your plane has a Dynon Avionics 100433-000 OAT installed (typically connected to the37-pin EMS connector, two White w/Black Stripe wires), simply connect either Whitew/Black Stripe wire on the installed OAT with one of the wires from the SV-OAT-340.The OAT is not polarity-sensitive.If our plane has a Dynon Avionics 100433-001 OAT installed (typically connected to theEDC-D10A remote compass, shielded cable with Blue, Red, and Yellow wires):o Tape, heat shrink, or otherwise isolate the shield - it will not be used.o Tape, heat shrink, or otherwise isolate the Red wire - it will not be used.o Connect the Blue wire to either White w/Black Stripe wire (not polarity sensitive)o Connect the Yellow wire to the other White w/Black Strip wire (not polaritysensitive) from the SV-OAT-340.PFD-Related SettingsOnce the physical ADAHRS installation is complete, it may be necessary to configure PFDrelatedADAHRS settings for the SkyView system. All ADAHRS settings are automatically sharedbetween displays in multi-display systems.5-6 SkyView System Installation Guide - Revision O