SkyView System Installation Guide - Dynon Avionics

More documents

Recommendations

Info

SV-ADAHRS-20X Installation and ConfigurationPhysical InstallationAs previously mentioned in the System Planning Section, there are no module-tomoduleproximity requirements when installing multiple SV-ADAHRS-20X modulesin an aircraft. For example, one SV-ADAHRS-20X may be installed on top ofanother SV-ADAHRS-20X module. Other installation location requirements stillapply.The diagram below shows the important mounting dimensions of the ADAHRS module withelectronic and pneumatic connections. Note that the figure applies to both the SV-ADAHRS-200and SV-ADAHRS-201 modules.OAT ConnectorFigure 23–SV-ADAHRS-20X Mounting Dimensions with Electronic and Pneumatic ConnectionsAdditional mounting location, orientation, and other installation requirements are described inthe System Planning section earlier in this manual. Please review this section when physicallyinstalling your with SV-ADAHRS-20X module(s).An ADAHRS module should be mounted within one degree of parallel to all three aircraft axes,with the pneumatic fittings facing toward the front of the aircraft. The module’s mounting tabs5-2 SkyView System Installation Guide - Revision O
SV-ADAHRS-20X Installation and Configurationmust be on the bottom. The label must be on the top. Figure 23 shows the correct orientationof the ADAHRS as it would appear if you were above the aircraft, looking down at it. Themodule will not operate properly if it is rotated or inverted in any other orientation.Dynon does not provide mounting hardware with SV-ADAHRS-20X. The mounting tabs on eachside of the module have holes sized for #10 fasteners, but it is up to the installer to decide howthe ADAHRS will be secured to the aircraft.We recommend that installers use button-head style non-ferrous fasteners (e.g., stainless steelor brass) in this location. Follow recommended torque practices when tightening the mountinghardware. Do not rivet the SV-ADAHRS-20X to the aircraft as this will hinder future removal ifnecessary.Do not use a magnetic driver when installing the ADAHRS. Doing so has thepotential to affect the factory magnetic calibration.SkyView Network ConnectionConnect the ADAHRS module to the SkyView network using the hardware mentioned in theSkyView System Construction Section or using equivalent hardware.If you have to install a connector on the end of a network cable, insert all pins into the D9connector. Refer to Appendix C: Wiring and Electrical Connections for details on connector pinoutsand wire colors.Remember to configure the network as described in the Network Setup and Statussection after connecting all modules to a display.Pneumatic PortsThe AOA, pitot, and static ports on the SV-ADAHRS-20X are equipped with 1/8” NPT Femalefittings. To attach your pitot and static lines to the module, you must use standard 1/8” NPTmale fittings at the end of each of the lines.SkyView’s attitude calculation requires airspeed from pitot and static. A GPSsource can be used as a backup if the pitot and/or static source fails, but shouldnot be the primary source.Do not use ferrous pneumatic fittings.To install, simply connect your static and pitot sources to the SV-ADAHRS-20X. If you areperforming a retrofit installation, consider “teeing” off of existing lines using a tee fitting.Reference the sticker on top of the respective module for pneumatic port identification.SkyView System Installation Guide - Revision O 5-3
Page 1:
SkyViewSystem Installation GuideThi
Page 6 and 7:
Revision Revision Date Descriptionh
Page 8 and 9:
Revision Revision Date DescriptionC
Page 11 and 12:
Table of ContentsContact Informatio
Page 13 and 14:
Table of ContentsTachometer .......
Page 15:
Table of Contents19. Appendix C: Wi
Page 18 and 19:
IntroductionAbout this GuideIn the
Page 21 and 22:
2. System PlanningInstallers should
Page 23 and 24:
System PlanningTemperature Specific
Page 25 and 26:
System PlanningIn order to provide
Page 27 and 28:
System Planningferrous material suc
Page 29 and 30:
SV-XPNDR-26XSystem PlanningThe SV-X
Page 31 and 32:
System PlanningSkyView System Const
Page 33 and 34: System PlanningTest SkyView Network
Page 35 and 36: System PlanningDynon Part NumberSV-
Page 37 and 38: System PlanningFigure 8- SkyView Sy
Page 39: System PlanningSoftware is in use.
Page 42 and 43: Basic SkyView Display OperationDisp
Page 44 and 45: Basic SkyView Display OperationA bu
Page 46 and 47: Basic SkyView Display OperationBasi
Page 48 and 49: Basic SkyView Display OperationYou
Page 50 and 51: Basic SkyView Display Operationthis
Page 52 and 53: Basic SkyView Display OperationFlig
Page 54 and 55: Basic SkyView Display OperationFirm
Page 57 and 58: 4. SV-D700 / SV-D1000 Installation
Page 59 and 60: SV-D700 / SV-D1000 Installation and
Page 67 and 68: Internal Time KeepingSV-D700 / SV-D
Page 83: 5. SV-ADAHRS-20X Installation and C
Page 87 and 88: SV-OAT-340 Location and Installatio
Page 89 and 90: Measurement UnitsSV-ADAHRS-20X Inst
Page 91 and 92: SV-ADAHRS-20X Installation and Conf
Page 93 and 94: 6. SV-MAP-270 Navigation Mapping So
Page 95 and 96: SV-ADAHRS-20X Installation and Conf
Page 97: SV-ADAHRS-20X Installation and Conf
Page 100 and 101: SV-EMS-220/221 Installation and Con
Page 134 and 135:
SV-EMS-220/221 Installation and Con
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 165 and 166:
8. SV-GPS-250 Installation and Conf
Page 167 and 168:
SV-GPS-250 Installation and Configu
Page 169 and 170:
9. SV-BAT-320 InstallationThis chap
Page 171 and 172:
SV-BAT-320 Installationvoltages to
Page 173:
SV-BAT-320 InstallationTest Procedu
Page 176 and 177:
Autopilot Servo Installation, Confi
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 197 and 198:
11. SV-XPNDR-26X Installation, Conf
Page 199 and 200:
SV-XPNDR-26X Installation, Configur
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Post Installation ChecksSV-XPNDR-26
Page 217 and 218:
12. SV-ARINC-429 Installation and C
Page 219 and 220:
SV-ARINC-429 Installation and Confi
Page 221 and 222:
ARINC Device ConnectionsSV-ARINC-42
Page 223 and 224:
Page 225:
Page 228 and 229:
Vertical Power VP-X Integration and
Page 230 and 231:
Vertical Power VP-X Integration and
Page 233 and 234:
14. SV-ADSB-470 Installation, Confi
Page 235 and 236:
SV-ADSB-470 Installation, Configura
Page 237 and 238:
Page 239 and 240:
Page 241:
Post Installation ChecksSV-ADSB-470
Page 244 and 245:
Accessory Installation and Configur
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
SV-COM-C25 Installation, Configurat
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Appendix A: Maintenance and Trouble
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Appendix B: SpecificationsSkyView E
Page 286 and 287:
Appendix B: SpecificationsSV-XPNDR-
Page 288 and 289:
Appendix B: SpecificationsSV-COM-C2
Page 290 and 291:
Appendix C: Wiring and Electrical C
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 309 and 310:
20. Appendix D: SV-EMS-220/221 Sens
Page 311 and 312:
21. Appendix E: Serial Data OutputA
Page 313 and 314:
` Appendix E: Serial Data OutputPos
Page 315 and 316:
Page 317 and 318:
` Appendix E: Serial Data OutputDYN
Page 319 and 320:
Page 321 and 322:
` Appendix E: Serial Data Output ZZ
Page 323:
` Appendix E: Serial Data OutputNME
Page 326:
Appendix F: User Data LogsThe Recen
show all

SkyView System Installation Guide - Dynon Avionics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?