SkyView System Installation Guide - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationIn multi-display systems, you can specify a reversion mode that automatically changesthe screen configuration to a specific layout when only one display remains powered on.For example, if you normally have your left display showing PFD, and your right displayshowing Engine and Map, you could configure reversion mode to show all three pagesautomatically on the remaining single display should the other fail.Menu items and settings available in the SCREEN LAYOUT SETUP menu include:General Rules – Settings under this menu control behavior of items contained under theSCREEN menu. This applies to all displays in the system, no matter which display youchange these settings from.o Show Layout Button: Determines whether the SCREEN > LAYOUT button isavailable for use. The SCREEN > LAYOUT button allows the pilot to dynamicallyrearrange the order of the PFD/ENGINE/MAP pages on a display.o Show Swap Button: Determines whether the SCREEN > SWAP button is availablefor use. The SCREEN > SWAP button allows the pilot to swap the entire contentsand page layouts of displays in a two-display SkyView System.This Display – Normal Operation: The options under this menu apply only to the displaythat you are currently working with, and only when the system is operating normally(when the display is not in reversion mode or swapped)o PFD Page, Engine Page, Map Page: For each of these entries, you can controlwhether each page is:• Required: The relevant page is always shown on this display. This isalways shown on this display. The relevant page button under theSCREEN menu is not available.• Allowed (Save State): This display remembers whether the relevant pagewas being shown across power cycles. The relevant SCREEN button turnsthat page on and off on this display.• Allowed (Not Shown at Boot): The relevant page is never on at boot. Therelevant page button under the SCREEN menu turns that page on and offon this display.• Allowed (Shown at Boot): The relevant page is always on at boot. Therelevant page button under the SCREEN menu turns that page on and offon this display.• NOT ALLOWED: The relevant page cannot be shown on this display. Therelevant SCREEN button is not available.Reversion Mode Configuration – When only one display is powered on in a multipledisplay configuration, the layout picked here is forcibly displayed. This behavior appliesequally whether all but one display in your system has failed or if you turn on oneSkyView display before all others (as some customers do to see engine instrumentsbefore engine start). This setting applies to all displays in the system, no matter whichdisplay you change this settings from.SkyView System Installation Guide - Revision O 4-25