SkyView System Installation Guide - Dynon Avionics

SV-D700 / SV-D1000 Installation and Configurationcategory is played or not. The settings that can be adjusted here that are not voice alert togglesare:VOLUME CONTROL / TEST – Sets the volume level. While in this menu, sound is playedcontinuously so that proper audio connectivity and volume levels can be confirmed.o In this menu only, audio is only outputted from the actual display that is in thesetup menu. This allows one to troubleshoot the physical audio connections. Inactual operation, only one of the displays transmits audio at a time. Whichdisplay happens to be transmitting is automatically managed by SkyView. Sinceall displays’ audio outputs are connected together (and to the intercom or audiopanel), this is transparent in actual use.BOOT SOUND – When set to ON, the system will say “Dynon SkyView” when it firststarts up.ANGLE OF ATTACK – This sets a pulsing, progressive tone that increases in frequency,similar in nature to a conventional reed type aircraft stall warning sound to a reed-typestall warning sound, although it is much more predictable in its progression. It can be setto start its pulsing tones at either the border of the yellow/green marks on the AOAbars, the middle of the yellow, or the yellow/red border. The pulsing tones start at thelevel selected and get progressively quicker and closer together until a solid tone isplayed at critical AOA (in the red.)o INHIBIT AOA BELOW AIRSPEED – Allows you to set an airspeed below which noAOA tones are played. This helps prevent nuisance alarms while on the groundand taxiing, especially in tail draggers.Contact InputsContact Input #1 – (Optional) External LEVEL Button. See the Autopilot section for detailedexplanation.Contact Input #2, #3, #4 are currently not supported. A future firmware update may enable thisfunctionality. Do not connect anything to these pins at this time.Reserved Connections for Future UseDo not connect anything to unspecified D37 connector pins (directly or using the displayharness). These are reserved for future use.Display SetupYou can access important information about a SkyView display as well as configure serial ports,characterize your display backlight behavior and specify other display-specific settings.How to Access Display Hardware InformationEnter the Display Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAYHARDWARE INFORMATION) to access important display hardware information. This menuSkyView System Installation Guide - Revision O 4-19