SkyView System Installation Guide - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationSerial PortWire FunctionRXSV-GPS-250PowerSV-GPS-250GroundTable 10 - SkyView Serial Port ConnectionsSkyView Display HarnessWire ColorsGray with Violet stripeSolid OrangeSolid BlackTraffic DevicesSkyView has the ability to receive aircraft traffic information from different devices, includingthe SV-XPNDR-26X, the Zaon XRX (with the ZAON set to “Garmin” output), the Garmin GTX 330/ 330ES transponders, and the Garrecht TRX-1500. If a device that can provide traffic isconnected to SkyView and configured (usually as a TIS serial traffic device under SETUP MENU >SYSTEM SETUP > SERIAL PORT SETUP), further traffic display options can be configured in SETUPMENU > TRAFFIC SETUP. The traffic display on both the PFD and MAP pages can be set toinclude just Traffic Advisories (TA), all targets, or no targets.Only one device can provide traffic information to SkyView at any moment. If youhave more than one device connected to SkyView that is capable of providingtraffic (such as, but not limited to, SV-XPNDR-26X (TIS), SV-ADSB-470, Zaon XRX,etc), the devices provide traffic information with the following priority, based onthe completeness of the traffic portrait they provide:1. SV-ADSB-470 with full traffic (ADS-B ground station reporting with radarcoverage)2. TIS transponder from SV-XPNDR-26X or Garmin GTX 330 / ES (when in anactive TIS coverage area)3. FLARM4. Zaon5. SV-ADSB-470 with partial traffic (ADS-B reception, but without groundADS-B station coverage or radar target inclusion).Dynon SV-XPNDR-26X TransponderSee the SV-XPNDR-26X Installation, Configuration, and Testing section for detailed instructionson how to set up the serial connection to the SV-XPNDR-26X.Note that if you are using a Dynon SV-XPNDR-26X Transponder, none of the encoder options inthe below sections should to be set for the Dynon SV-XPNDR-26X module to receive pressurealtitude. Instead, when the Transponder is set up as described in the SV-XPNDR-26XInstallation, Configuration, and Testing section, it is automatically configured to receivepressure altitude from SkyView. Alternatively, systems that require the use of an externalaltitude encoder can be configured per the following section to have SkyView pass along anexternal pressure altitude source.SkyView System Installation Guide - Revision O 4-13