SkyView System Installation Guide - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationFigure 21–SkyView Network Configuration with Firmware UpdateIf you see a screen similar to the one in Figure 21, simply press UPDATE to synchronize thefirmware running on the equipment in the SkyView network.To check on SkyView network status, enter the NETWORK STATUS… Menu in the NetworkSetup Menu (SETUP MENU > SYSTEM SETUP > NETWORK SETUP > NETWORK STATUS…).The Network Status Page shows all displays, modules, servos, and other Dynon Avionicsproducts installed on the SkyView network via the D9 SkyView Network connectors. Thisincludes the following devices: SV-D1000 and SV-D700 DISPLAYS, SV-ADAHRS-20X modules, SV-EMS-220/221 modules, SV-ARINC-429 modules, and Dynon Autopilot Servos. It does NOTinclude any non-Dynon devices or any of the following Dynon devices that connect via amethod other than SkyView Network: SV-XPNDR-26X transponder, OAT or individual enginesensors, SV-GPS-250.SkyView Network has redundancy and error detection features which allow it to detect andannunciate module and SkyView Network wiring faults. In the event that SkyView reports aproblem with an ADAHRS, EMS module, autopilot servo, or a problem with the “standbynetwork”, this NETWORK STATUS page will provide more information about the nature of theproblem.Ethernet ConnectionSkyView systems containing more than one display should ideally have their Ethernet portsconnected together for best operation. See the SkyView System Construction section in thismanual for further information about Ethernet.4-10 SkyView System Installation Guide - Revision O