SkyView System Installation Guide - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationIn the event of an electrical failure that causes SkyView to run on the SV-BAT-320, the SV-BAT-320 supplies power to the SkyView display it is connected to, along with any connected SV-ADAHRS-20X, SV-EMS-220/221, SV-ARINC-429, and SV-GPS-250 modules. A fully charged SV-BAT-320 can keep most SkyView systems operating for at least 60 minutes. The SV-BAT-320does not supply (backup) power to the following SkyView system devices:Autopilot servosHeated AOA/Pitot ProbeSV-ADSB-470SV-COM-425SV-XPNDR-26XAny non-Dynon deviceSkyView displays are only compatible with Dynon’s SV-BAT-320 backup battery. Donot connect a lead-acid battery or any other battery to the connection reserved forthe SV-BAT-320 as the charging algorithm is optimized for the SV-BAT-320.Connecting any other battery may have detrimental consequences. Damagecaused by connecting such a battery will not be repaired under warranty.See the Homemade Wire Harness Considerations section for importantspecifications that must be adhered to for the SV-BAT-320 to charge properlywhen used with a non-Dynon harness.SkyView Network ConnectorsThe two D9 connectors on the back of a SkyView display are SkyView network connectors. Theyhave identical pin-outs and are electrically connected inside the display (i.e., they arecompletely interchangeable). Installers may use either connector or both connectors in SkyViewinstallations. Reference Table 64 on page 19-8 for SkyView Network Connector pin-outinformation.Note that these connectors are not serial port connectors.Network Setup and StatusOnce all SkyView modules are connected in a network, either in a bench top test or permanentinstallation, turn the display(s) on. You will see the display boot up and the status LEDs on themodules light up.A tail number on the Aircraft Information Page (SETUP MENU > SYSTEM SETUP >AIRCRAFT INFORMATION) is required for network configuration.If you have more than one display in your SkyView system, the tail number onlyneeds to be set on the display that you initially perform the Network Configurationon. At network configuration time, all other displays that are set to the default tail4-8 SkyView System Installation Guide - Revision O