SkyView System Installation Guide - Dynon Avionics

Basic SkyView Display OperationRed and Yellow Start – When the above setting is set to “YES”, these settings how farabove or below the aircraft’s current altitude the red and yellow colors persist.Autopilot Setup MenuThis menu is not accessible until the autopilot servos in the system have beensuccessfully calibrated and tested. Reference the Autopilot Servo Calibration andTest Procedures Section of this guide for more information.This menu contains links to the following menus:Roll Axis–Enter this menu to configure autopilot roll axis setup and tuning parameters.Pitch Axis–Enter this menu to configure autopilot pitch axis setup and tuningparameters.Disengage Button–Enter this menu to configure disengage button options such as holdto engage, enable broken line detect, and control wheel steering mode.Transponder Setup MenuThis menu is not accessible unless a SV-XPNDR-26X is setup and configured.Reference the SV-XPNDR-26X Installation, Configuration, and Testing Section of thisguide for more information.This menu contains options that are used to set up and configure the SV-XPNDR-26X module.Reference the SV-XPNDR-26X Installation, Configuration, and Testing Section of this guide formore information.Hardware Calibration MenuThis menu contains links to the following menus:ADAHRS Calibration–Enter this menu to make altitude adjustments (e.g., baro andaltitude adjust) and access the compass and AOA calibration wizards.EMS Calibration–Enter this menu for EMS sensor calibration. You will have options tocalibrate fuel tanks and position potentiometers that have been mapped in the SensorInput Mapping Wizard. Calibration wizards contain onscreen instructions.Servo Calibration–Enter this menu for autopilot servo calibration. Reference theAutopilot Servo Installation, Configuration, and Calibration Section of this guide formore details.Note that if an ADAHRS, EMS, or Servos are not present on the SkyView network,this menu will note the absence by displaying “(EMS NOT DETECTED)” ,“(ADAHRSNOT DETECTED)”, or “(SERVOS NOT INSTALLED)”SkyView System Installation Guide - Revision O 3-13